Home › Vehicle Interior › LIGHTING › TURN SIGNAL FLASHER ASSEMBLY
RM27M0U _58 Vehicle Interior _049133 LIGHTING _0234259 TURN SIGNAL FLASHER ASSEMBLY G

LIGHTING  TURN SIGNAL FLASHER ASSEMBLY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 81981A 1.INSPECT TURN SIGNAL FLASHER

E277435E03
2.49,1.917 3.01,1.76 true 2.271,1.906 2.635,1.063 true 1.906,1.927 2.135,0.823 true 1.135,1.896 0.427,1.073 true 0.833,1 1.313,1.885 true 1.531,1.906 1.146,0.646 true 2.073,2.219 2.229,2.875 true 0.146,0.021 0.469,0.323 0.323,0.302 10 false *a 3.042,1.656 3.26,1.844 0.219,0.188 10 false B 2.552,0.875 2.771,1.063 0.219,0.188 10 false LL 2.104,0.646 2.323,0.833 0.219,0.188 10 false E 1.021,0.469 1.271,0.656 0.25,0.188 10 false EL 0.656,0.833 0.906,1.021 0.25,0.188 10 false ER 0.26,0.906 0.51,1.094 0.25,0.188 10 false LR 2.115,2.885 2.49,3.073 0.375,0.188 10 false HAZ

a.

Disconnect the turn signal flasher connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 (E) - Body ground Always Below 1 Ω



c.

Connect the turn signal flasher connector.


d.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
8 (LR) - 4 (E) Hazard warning switch off Below 1 V
Hazard warning switch on Alternating between 11 to 14 V and below 1 V (60 to 120 times per minute)
2 (LL) - 4 (E) Hazard warning switch off Below 1 V
Hazard warning switch on Alternating between 11 to 14 V and below 1 V (60 to 120 times per minute)
1 (B) - 4 (E) Always 11 to 14 V
6 (EL) - 4 (E) Ignition switch ON Headlight dimmer switch (turn left) off 9 V or higher
Ignition switch ON Headlight dimmer switch (turn left) on Below 1 V
7 (ER) - 4 (E) Ignition switch ON Headlight dimmer switch (turn right) off 9 V or higher
Ignition switch ON Headlight dimmer switch (turn right) on Below 1 V
12 (HAZ) - 4 (E) Hazard warning switch off 9 V or higher
Hazard warning switch on Below 1 V


If the result is not as specified, there may be a malfunction in the turn signal flasher.

Text in Illustration
*a Rear view of wire harness connector
(to Turn Signal Flasher)