Home › Vehicle Interior › LIGHTING › HEADLIGHT LEVELING SWITCH
RM27M0U _58 Vehicle Interior _049133 LIGHTING _0234263 HEADLIGHT LEVELING SWITCH G

LIGHTING  HEADLIGHT LEVELING SWITCH  INSPECTION  


PROCEDURE

Hide 84152 1.INSPECT HEADLIGHT LEVELING SWITCH

E189909E02
0.075,0 0.327,0.181 0.253,0.181 10 *a 2.763,1.019 2.919,1.201 0.156,0.181 10 B 2.059,1.816 2.215,1.998 0.156,0.181 10 T 0.611,1.04 0.767,1.221 0.156,0.181 10 E 1.902,1.312 2.091,1.794 false 2.126,1.242 2.727,1.106 false 0.763,1.145 1.322,1.225 false

a.

Check the voltage.

i.

Connect the battery positive (+) lead to terminal 1 (B) and the negative (-) lead to terminal 5 (E).


ii.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
1 (B) - 2 (T) 0 10.4 to 11.2 V
1 8.52 to 9.24 V
2 6.6 to 7.32 V
3 4.68 to 5.40 V
4 2.76 to 3.48 V
5 0.84 to 1.56 V


If the result is not as specified, replace the headlight leveling switch.

Text in Illustration
*a Component without harness connected
(Headlight Leveling Switch)



b.
E189909E03
0.058,0 0.293,0.181 0.236,0.181 10 *a 1.789,1.745 2.080,1.926 0.291,0.181 10 ILL+ 1.117,1.739 1.373,1.920 0.256,0.181 10 ILL- 1.567,1.308 1.284,1.74 false 1.726,1.321 1.907,1.745 false

Check the illumination.

i.

Apply battery voltage to the connector and check the illumination condition.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 3 (ILL+)
Battery negative (-) → Terminal 4 (ILL-)
Illuminates


If the result is not as specified, replace the headlight leveling switch.

Text in Illustration
*a Component without harness connected
(Headlight Leveling Switch)