Home › Vehicle Interior › WIPER / WASHER › WIPER AND WASHER SYSTEM
RM27M0U _58 Vehicle Interior _049134 WIPER / WASHER _0234267 WIPER AND WASHER SYSTEM U

WIPER / WASHER  WIPER AND WASHER SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the Techstream to read the Data List allows values or status of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the DATA LIST information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Warm up the engine.


b.

Turn the ignition switch OFF.


c.

Connect the Techstream to the DLC3.


d.

Turn the ignition switch ON.


e.

Turn the Techstream on.


f.

Enter the following menus: Body / Combination Meter / Data List.


g.

According to the display on the Techstream, read the "Data List".

Combination Meter
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Washer Switch Washer fluid level warning switch / ON or OFF ON: Washer jar is empty
OFF: Washer jar is full
-