85221B
1.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH
Remove the nut, wiper arm and blade.
85211B
2.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH
Remove the nut, wiper arm and blade.
53383
3.REMOVE HOOD TO COWL TOP SEAL
Using a clip remover, detach the 16 claws and remove the cowl top seal.
53867H
4.REMOVE FRONT FENDER TO COWL SIDE SEAL LH
Using a clip remover, detach the claw and remove the cowl side seal.
53866J
5.REMOVE FRONT FENDER TO COWL SIDE SEAL RH
Use the same procedures described for the LH side.
55781E
6.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
Remove the 2 clips.
Detach the 8 claws and remove the ventilator louver.
7.REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY
Disconnect the connector.
Remove the nut.
Remove the 4 bolts and wiper motor and link assembly.
85110
8.REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY
Using a screwdriver, disconnect the rod of the wiper link from the wiper motor as shown in the illustration.
Tape the screwdriver tip before use.
Remove the 3 bolts.
Rotate the crank arm clockwise and remove the wiper motor.