Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA POLE
RM27M0U _56 Audio / Visual / Telematics _049135 AUDIO / VIDEO _0234277 RADIO ANTENNA POLE A

AUDIO / VIDEO  RADIO ANTENNA POLE  INSTALLATION  


PROCEDURE

Hide 86309B 1.INSTALL PULL TOP ANTENNA POLE SUB-ASSEMBLY

a.
B355089

Install the pull top antenna pole sub-assembly and tighten it by hand until it is fully seated.


b.

Using an 8 mm (0.315 in.) wrench or antenna mast tool, tighten the pull top antenna pole sub-assembly clockwise approximately 1/8 turn (20 to 45 degrees).

HINT:
·

Do not overtighten the pull top antenna pole sub-assembly. Tighten the pull top antenna pole sub-assembly with your fingers, not your whole hand.

·

Do not use pliers to tighten the pull top antenna pole sub-assembly as it can leave marks on the pull top antenna pole sub-assembly surface.

·

The pull top antenna pole sub-assembly cannot be tightened by hand to the proper torque specification.



Torque:
3.3 N*m (3.4 kgf*cm, 29 in.*lbf)