86160
1.INSPECT FRONT NO. 1 SPEAKER ASSEMBLY (for Standard)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Always | 2 Ω |
If the result is not as specified, replace the front No. 1 speaker assembly.
| *a | Component without harness connected
(Front No. 1 Speaker Assembly) |
86160
2.INSPECT FRONT NO. 1 SPEAKER ASSEMBLY (for 12 Speakers)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Always | 1.8 to 2.6 Ω |
If the result is not as specified, replace the front No. 1 speaker assembly.
| *a | Component without harness connected
(Front No. 1 Speaker Assembly) |
86160A
3.INSPECT FRONT NO. 3 SPEAKER ASSEMBLY (for 12 Speakers)
When there is a malfunction such as noise from a speaker or no sound at all, replace the speaker with a new one and check that the malfunction disappears.
Malfunction disappears.
Connect the connectors to the front No. 3 speaker assemblies.
When there is a possibility that either the right or left front No. 3 speaker assembly is defective, inspect by interchanging the right one with the left one.
Perform the inspection above on both the LH and RH sides.