86160P
1.INSPECT FRONT NO. 2 SPEAKER ASSEMBLY (for Standard)
When there is a malfunction such as noise from a speaker or no sound at all, replace the speaker with a new one and check that the malfunction disappears.
Malfunction disappears.
Connect the connectors to the front No. 2 speaker assemblies.
When there is a possibility that either the right or left front No. 2 speaker assembly is defective, inspect by interchanging the right one with the left one.
Perform the inspection above on both the LH and RH sides.
86160P
2.INSPECT FRONT NO. 2 SPEAKER ASSEMBLY (for 12 Speakers)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 4 | Always | 1.5 to 2.5 Ω |
| 3 - 1 | Always | Below 1 Ω |
| 4 - 2 |
If the result is not as specified, replace the front No. 2 speaker assembly.
| *a | Component without harness connected
(Front No. 2 Speaker Assembly) |
86160R
3.INSPECT FRONT NO. 4 SPEAKER ASSEMBLY (for Standard)
Temporarily replace the front No. 4 speaker assembly with a new or normally functioning one.
Malfunction disappears.
Connect the connectors to the front No. 4 speaker assembly.
86160R
4.INSPECT FRONT NO. 4 SPEAKER ASSEMBLY (for 12 Speakers)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Always | 1.5 to 2.1 Ω |
If the result is not as specified, replace the front No. 4 speaker assembly.
| *a | Component without harness connected
(Front No. 4 Speaker Assembly) |