Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY(for Power Seat)
RM27M0U _58 Vehicle Interior _049136 SEAT _0234295 FRONT SEAT ASSEMBLY(for Power Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Power Seat)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

If the side airbag has deployed, replace the front seat airbag assembly LH, separate type front seatback frame sub-assembly LH, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.



Hide 71910A 2.REMOVE FRONT SEAT HEADREST ASSEMBLY

a.

Remove the front seat headrest assembly.


Hide 72158C 3.REMOVE INNER SEAT TRACK BRACKET COVER LH

a.

Operate the front power seat switch LH (slide switch) to move the seat to the foremost position.


b.
B354880

Detach the clip to remove the inner seat track bracket cover LH in the direction indicated by the arrow shown in the illustration.


Hide 72138H 4.REMOVE OUTER SEAT TRACK BRACKET COVER LH

a.
B354881

Detach the clip to remove the outer seat track bracket cover LH in the direction indicated by the arrow shown in the illustration.


Hide 5.REMOVE FRONT SEAT ASSEMBLY LH

a.
B354882

Remove the 2 bolts.


b.

Operate the front power seat switch LH (slide switch) to move the seat to the rearmost position.


c.
B354883

Remove the 2 bolts.


d.

Operate the front power seat switch LH (slide switch) to move the seat to the center position and operate the front power seat switch LH (reclining switch) to move the seatback to the upright position.


e.

w/ Vertical Adjuster:

Operate the front power seat switch LH (vertical switch) to move the seat to the highest position.


f.

w/ Leg Support Adjustment Switch:

Operate the seat variable cushion switch to move the seat to the foremost position.


g.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the battery negative (-) terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



h.
U152060E02
1.625,1.208 1.802,1.625 false 2.063,1.219 2.26,1.458 false 2.448,0.958 2.802,1.24 false 1.802,1.635 1.979,1.792 0.177,0.156 10 false *2 2.271,1.5 2.448,1.656 0.177,0.156 10 false *1 2.844,1.198 3.021,1.354 0.177,0.156 10 false *3

Detach the clamp and disconnect the connector of the front seat inner belt assembly LH.


i.

Disconnect the connector of the front seat wire LH.


j.

Disconnect the connector of the front seat airbag assembly LH.

Text in Illustration
*1 Front Seat Inner Belt Assembly LH
*2 Front Seat Wire LH
*3 Front Seat Airbag Assembly LH

i.

Place a finger on the slider, slide the slider to release the lock, and then disconnect the front seat side airbag connector.

C190412E09
1.972,0.859 1.972,2.125 false 1.895,2.153 2.065,2.318 0.170,0.165 10 *1 3.653,0.859 3.653,2.125 false 3.576,2.153 3.746,2.318 0.170,0.165 10 *1

Text in Illustration
*1 Slider - -



k.

Remove the front seat assembly LH from the vehicle.

NOTICE:

Be careful not to damage the vehicle body.