69040A
1.INSPECT FRONT DOOR LOCK ASSEMBLY LH (w/ Power Window)
Check the door lock motor.
Apply battery voltage to the door lock motor and check operation of the door lock motor.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 4 (L)
Battery negative (-) → Terminal 1 (UL) |
Lock |
| Battery positive (+) → Terminal 1 (UL)
Battery negative (-) → Terminal 4 (L) |
Unlock |
If the result is not as specified, replace the door lock assembly.
Check the door lock position switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 7 (E) - 8 (LSSR) | Unlock | Below 1 Ω |
| Lock | 10 kΩ or higher |
If the result is not as specified, replace the door lock assembly.
Check the door lock and unlock switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 9 (L) - 7 (E) | Lock | Below 1 Ω |
| 9 (L) - 7 (E)
10 (UL) - 7 (E) |
OFF | 10 kΩ or higher |
| 10 (UL) - 7 (E) | Unlock | Below 1 Ω |
If the result is not as specified, replace the door lock assembly.
69030A
2.INSPECT FRONT DOOR LOCK ASSEMBLY RH (w/ Power Window)
Check the door lock motor.
Apply battery voltage to the door lock motor and check operation of the door lock motor.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 4 (L)
Battery negative (-) → Terminal 1 (UL) |
Lock |
| Battery positive (+) → Terminal 1 (UL)
Battery negative (-) → Terminal 4 (L) |
Unlock |
If the result is not as specified, replace the door lock assembly.
Check the door lock position switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 7 (LSSR) - 8 (E) | Unlock | Below 1 Ω |
| Lock | 10 kΩ or higher |
If the result is not as specified, replace the door lock assembly.