Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
69284D
3.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH
74272A
4.REMOVE REAR UPPER DOOR ARMREST BASE PANEL LH
67674A
5.REMOVE REAR DOOR FRAME GARNISH LH
74222A
6.REMOVE REAR DOOR ARMREST COVER LH
67604
7.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
67626C
8.REMOVE REAR NO. 2 DOOR TRIM BRACKET
67842E
9.REMOVE REAR DOOR SERVICE HOLE COVER LH
68152C
10.REMOVE REAR DOOR GLASS RUN LH
67408F
11.REMOVE REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY LH
68104
12.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
69060A
13.REMOVE REAR DOOR LOCK ASSEMBLY LH
69740D
14.REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
69780B
15.REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH