READ DATA LIST
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Connect the Techstream to the DLC3.
Turn the ignition switch ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body / Data List.
Check the results by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| D Door Courtesy SW | Driver side door courtesy light switch signal / ON or OFF | ON: Driver side door is open
OFF: Driver side door is closed |
- |
| P Door Courtesy SW | Passenger side door courtesy light switch signal / ON or OFF | ON: Passenger side door is open
OFF: Passenger side door is closed |
- |
| RR Door Courtesy SW*1, *2 | Rear door RH courtesy light switch signal / ON or OFF | ON: Rear door RH is open
OFF: Rear door RH is closed |
- |
| RL Door Courtesy SW*1, *2 | Rear door LH courtesy light switch signal / ON or OFF | ON: Rear door LH is open
OFF: Rear door LH is closed |
- |
| D-Door Lock Pos SW | Driver side door unlock detection switch signal / ON or OFF | ON: Driver side door is unlocked
OFF: Driver side door is locked |
- |
| P-Door Lock Pos SW | Passenger side door unlock detection switch signal / ON or OFF | ON: Passenger side door is unlocked
OFF: Passenger side door is locked |
- |
| RR-Door Lock Pos SW*1, *2 | Rear door RH lock position switch signal / ON or OFF | ON: Rear door RH is unlocked
OFF: Rear door RH is locked |
- |
| RL-Door Lock Pos SW*1, *2 | Rear door LH unlock detection switch signal / ON or OFF | ON: Rear door LH is unlocked
OFF: Rear door LH is locked |
- |
| Door Lock SW-Lock | Door manual lock switch signal / ON or OFF | ON: Door control switch (for driver side door) is turned to lock position
OFF: Door control switch (for driver side door) is turned to unlock position |
- |
| Door Lock SW-Unlock | Door manual unlock switch signal / ON or OFF | ON: Door control switch (for driver side door) is turned to unlock position
OFF: Door control switch (for driver side door) is turned to lock position |
- |
| Door Key SW-Lock | Door key linked lock switch signal / ON or OFF | ON: Driver side door key cylinder is turned to lock position
OFF: Driver side door key cylinder is turned to unlock position |
- |
| Door Key SW-Unlock | Door key linked unlock switch signal / ON or OFF | ON: Driver side door key cylinder is turned to unlock position
OFF: Driver side door key cylinder is turned to lock position |
- |
| Key Unlock Warning SW | Unlock warning switch / ON or OFF | ON: Ignition key is inserted
OFF: Ignition key is not inserted |
- |
*1: for Double Cab
*2: for CrewMax
PERFORM ACTIVE TEST
Using the Techstream to perform Active Tests allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the Techstream to the DLC3.
Turn the ignition switch ON.
Enter the following menus: Body Electrical / Main Body / Active Test.
Perform the Active Test by referring to the table below.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Wireless buzzer | Sounds wireless buzzer | ON/OFF | - |
| Hazard | Flasher relay | ON/OFF | - |
| Vehicle Horn | Sounds vehicle horn | ON/OFF | - |
| Security Horn | Sounds security horn | ON/OFF | - |
| Door Lock | Operate door lock motor | LOCK/UNLOCK | - |
| D-Door Unlock | Operate driver side door lock motor unlock | ON/OFF | - |