CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK)
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbols) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| J4-9 (LSWD) - Body ground | P - Body ground | Front door unlock detection switch LH input | Front door LH UNLOCK | Below 1 V |
| Front door LH LOCK | 11 to 14 V (or pulse generation [see waveform 1 or 2]) | |||
| J3-27 (LSWP) - Body ground | V - Body ground | Front door unlock detection switch RH input | Front door RH UNLOCK | Below 1 V |
| Front door RH LOCK | 11 to 14 V (or pulse generation [see waveform 3 or 4]) | |||
| DC-1 (LSWL) - Body ground | GR - Body ground | Rear door unlock detection switch LH input | Rear door LH UNLOCK | Below 1 V |
| Rear door LH LOCK | 11 to 14 V (or pulse generation [see waveform 5 or 6]) | |||
| J3-5 (LSWR) - Body ground | Y - Body ground | Rear door unlock detection switch RH input | Rear door RH UNLOCK | Below 1 V |
| Rear door RH LOCK | 11 to 14 V (or pulse generation [see waveform 7 or 8]) | |||
| DD-3 (ACT+) - Body ground | W - Body ground | Door lock motor LOCK drive output | Door control switch or front door key cylinder LH OFF | Below 1 V |
| Door control switch or front door key cylinder LH LOCK | 11 to 14 V | |||
| J4-5 (ACTD) - Body ground | P - Body ground | Door lock motor UNLOCK drive output | Door control switch or front door key cylinder LH UNLOCK | 11 to 14 V |
| Door control switch or front door key cylinder LH OFF | Below 1 V | |||
| DD-2 (ACT-) - Body ground | GR - Body ground | Door lock motor UNLOCK drive output | Door control switch or front door key cylinder LH UNLOCK | 11 to 14 V |
| Door control switch or front door key cylinder LH OFF | Below 1 V | |||
| DC-24 (ACT+) - Body ground | W - Body ground | Door lock motor LOCK drive output | Door control switch or front door key cylinder LH OFF | Below 1 V |
| Door control switch or front door key cylinder LH LOCK | 11 to 14 V | |||
| DC-23 (ACT-) - Body ground | L - Body ground | Door lock motor UNLOCK drive output | Door control switch or front door key cylinder LH UNLOCK | 11 to 14 V |
| Door control switch or front door key cylinder LH OFF | Below 1 V | |||
| DD-53 (L2) - Body ground | G - Body ground | Front door key switch LH LOCK input | Front door key cylinder LH LOCK | Below 1 V |
| Ignition switch OFF, all doors closed and front door key cylinder LH neutral position | 11 to 14 V (or pulse generation [see waveform 9 or 10]) | |||
| J4-10 (UL3) - Body ground | B - Body ground | Front door key switch LH UNLOCK input | Front door key cylinder LH UNLOCK | Below 1 V |
| Ignition switch OFF, all doors closed and front door key cylinder LH neutral position | 11 to 14 V (or pulse generation [see waveform 9 or 10]) | |||
| DD-49 (L1) - Body ground | B - Body ground | Door control switch LOCK input | Door control switch OFF | 10 kΩ or higher |
| Door control switch LOCK | Below 1 Ω | |||
| DD-52 (UL1) - Body ground | R - Body ground | Front door control switch LH UNLOCK input | Front door control switch LH OFF | 10 kΩ or higher |
| Front door control switch LH UNLOCK | Below 1 Ω | |||
| DD-40 (UL1) - Body ground | W - Body ground | Front door control switch RH UNLOCK input | Front door control switch RH OFF | 10 kΩ or higher |
| Front door control switch RH UNLOCK | Below 1 Ω | |||
| DB-21 (GND1,GND2) - Body ground | B - Body ground | Power ground | Always | Below 1 Ω |
| DB-13 (BECU) - Body ground | GR - Body ground | +B power source (signal system) | Always | 11 to 14 V |
If the result is not as specified, the ECU may have a malfunction.
Using an oscilloscope, check the waveform 1.
| Item | Content |
|---|---|
| Terminal No. (Symbols) | J4-9 (LSWD) - Body ground |
| Tool Setting | 5 V/DIV., 20 ms/DIV. |
| Condition | Front door LH LOCK |
Using an oscilloscope, check the waveform 2.
| Item | Content |
|---|---|
| Terminal No. (Symbols) | J4-9 (LSWD) - Body ground |
| Tool Setting | 5 V/DIV., 20 ms/DIV. |
| Condition | Front door LH LOCK |
Using an oscilloscope, check the waveform 3.
| Item | Content |
|---|---|
| Terminal No. (Symbols) | J3-27 (LSWP) - Body ground |
| Tool Setting | 5 V/DIV., 20 ms/DIV. |
| Condition | Front door RH LOCK |
Using an oscilloscope, check the waveform 4.
| Item | Content |
|---|---|
| Terminal No. (Symbols) | J3-27 (LSWP) - Body ground |
| Tool Setting | 5 V/DIV., 20 ms/DIV. |
| Condition | Front door RH LOCK |
Using an oscilloscope, check the waveform 5.
| Item | Content |
|---|---|
| Terminal No. (Symbols) | DC-1 (LSWL) - Body ground |
| Tool Setting | 5 V/DIV., 20 ms/DIV. |
| Condition | Rear door LH LOCK |
Using an oscilloscope, check the waveform 6.
| Item | Content |
|---|---|
| Terminal No. (Symbols) | DC-1 (LSWL) - Body ground |
| Tool Setting | 5 V/DIV., 20 ms/DIV. |
| Condition | Rear door LH LOCK |
Using an oscilloscope, check the waveform 7.
| Item | Content |
|---|---|
| Terminal No. (Symbols) | J3-5 (LSWR) - Body ground |
| Tool Setting | 5 V/DIV., 20 ms/DIV. |
| Condition | Rear door RH LOCK |
Using an oscilloscope, check the waveform 8.
| Item | Content |
|---|---|
| Terminal No. (Symbols) | J3-5 (LSWR) - Body ground |
| Tool Setting | 5 V/DIV., 20 ms/DIV. |
| Condition | Rear door RH LOCK |
Using an oscilloscope, check the waveform 9.
| Item | Content |
|---|---|
| Terminal No. (Symbols) | DD-53 (L2) - Body ground
J4-10 (UL3) - Body ground |
| Tool Setting | 5 V/DIV., 20 ms/DIV. |
| Condition | Ignition switch OFF, all doors closed and front door lock key cylinder LH neutral position |
Using an oscilloscope, check the waveform 10.
| Item | Content |
|---|---|
| Terminal No. (Symbols) | DD-53 (L2) - Body ground
J4-10 (UL3) - Body ground |
| Tool Setting | 5 V/DIV., 20 ms/DIV. |
| Condition | Ignition switch OFF, all doors closed and front door lock key cylinder LH neutral position |