CHECK MAIN BODY ECU
Disconnect the J1, J4, DA, DB and DD ECU connectors.
Measure the resistance and voltage according to the value(s) in the table below.
| Terminal No. (Symbols) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| DB-21 (GND1) - Body ground | B - Body ground | Ground | Always | Below 1 Ω |
| DB-21 (GND2) - Body ground | ||||
| DB-13 (BECU) - Body ground | GR - Body ground | Power source | Always | 11 to 14 V |
| DA-1 (ALTB) - Body ground | B - Body ground | |||
| J4-24 (DCTY) - Body ground | GR - Body ground | Front door courtesy switch LH signal | Switch pushed (Door closed) | 10 kΩ or higher |
| Switch Not pushed (Door open) | Below 1 Ω | |||
| J1-5 (KSW) - Body ground | B - Body ground | Key unlock warning switch signal | No key is in ignition key cylinder | 10 kΩ or higher |
| Key is in ignition key cylinder | Below 1 Ω |
lf the result is not as specified, the ECU may have a malfunction.