Home › Vehicle Interior › ENGINE HOOD / DOOR › HOOD SUPPORT
RM27M0U _58 Vehicle Interior _049138 ENGINE HOOD / DOOR _0234333 HOOD SUPPORT A

ENGINE HOOD / DOOR  HOOD SUPPORT  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Install the hood support assembly LH while holding the hood.


NOTICE:
·

Do not touch the extendable portion of the rod to prevent foreign objects from attaching to the hood support assembly LH surface.

·

Do not push the hood support assembly LH sideways because the hood support assembly LH may bend.



HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 53440B 1.INSTALL NO. 1 HOOD SUPPORT BOLT

a.
B354834

Install the No. 1 hood support bolt.

Torque:
22 N*m (224 kgf*cm, 16 ft.*lbf)

CAUTION:

Install the No. 1 hood support bolt while supporting the hood by hand.



Hide 53450A 2.INSTALL HOOD SUPPORT ASSEMBLY LH

B354835

a.

Install the 2 stop rings to the hood support assembly LH.


b.

Attach the 2 ball joints to install the hood support assembly LH.


c.

Check that the hood support assembly LH is connected to the ball joint and cannot be pulled off.

CAUTION:

Install the hood support assembly LH while holding the hood.


NOTICE:

Check that the hood support assembly LH is engaged in the ball joint and it cannot be pulled out.