Home › Vehicle Interior › ENGINE HOOD / DOOR › HOOD
RM27M0U _58 Vehicle Interior _049138 ENGINE HOOD / DOOR _0234334 HOOD N

ENGINE HOOD / DOOR  HOOD  ADJUSTMENT  


CAUTION / NOTICE / HINT

B057104E34
0.219,1.365 1.354,1.583 1.135,0.219 10 false Centering Bolt 2.146,1.469 3.208,1.698 1.063,0.229 10 false Standard Bolt

HINT:
·

Centering bolts are used to mount the hood hinge and hood lock. The hood and hood lock cannot be adjusted with the centering bolts on. Substitute the centering bolts with standard bolts (with washers) when making adjustments.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 53301 1.ADJUST HOOD SUB-ASSEMBLY

a.
B166027

Adjust the hood sub-assembly position.

i.

Loosen the 4 hinge bolts.


ii.

Move the hood sub-assembly and adjust the clearance between the hood sub-assembly and front fender.


iii.

Tighten the 4 hinge bolts after the adjustment.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


iv.
B166028

Adjust the cushion rubber so that the height of the hood sub-assembly and fender are aligned.

HINT:

Raise or lower the hood sub-assembly front end by turning the cushion rubber.




b.

Adjust the hood lock assembly.

i.
B354830E02
1.521,1.448 2.177,1.448 false 2.188,1.365 2.417,1.542 0.229,0.177 10 false *1

Using a screwdriver, remove the hood lock nut cap as shown in the illustration.

HINT:

Tape the screwdriver tip before use.


Text in Illustration
*1 Protective Tape


ii.
B354831

Loosen the 2 bolts and hood lock bolt.


iii.

Adjust the hood lock assembly position so that the striker can enter it smoothly.


iv.

Tighten the bolts after the adjustment.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


v.

Install a new hood lock nut cap.