Home › Vehicle Interior › ENGINE HOOD / DOOR › REAR DOOR(for CrewMax)
RM27M0U _58 Vehicle Interior _049138 ENGINE HOOD / DOOR _0234341 REAR DOOR(for CrewMax) A

ENGINE HOOD / DOOR  REAR DOOR(for CrewMax)  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 69284D 3.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH

a.
B166242

Using a screwdriver, detach the 4 claws and remove the inside handle bezel.

HINT:

Tape the screwdriver tip before use.



Hide 74272A 4.REMOVE REAR UPPER DOOR ARMREST BASE PANEL LH

a.
E278381

Using a moulding remover A, detach the 2 clips and 5 claws, and remove the rear upper door armrest base panel LH.


b.
E278383

Disconnect the connector.


Hide 84810D 5.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY

Hide 67674A 6.REMOVE REAR DOOR FRAME GARNISH LH

a.
B169253

Detach the 5 clips and remove the rear door frame garnish.


Hide 74222A 7.REMOVE REAR DOOR ARMREST COVER LH

Hide 67604 8.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

a.
B354857E02
0.615,0.865 0.615,1.031 false 0.625,3.188 0.625,3.354 false 0.063,2.135 1.344,2.469 1.281,0.333 12 true for 12 Speakers: 0.063,0.042 1.323,0.333 1.26,0.292 12 true for Standard: 0.49,1.063 0.792,1.26 0.302,0.198 10 false Clip 0.521,3.375 0.823,3.573 0.302,0.198 10 false Clip

Remove the 2 screws.


b.

Using a clip remover, remove the clip.


c.

for Standard:

i.

Detach the 10 clips and remove the trim board.



d.

for 12 Speakers:

i.

Detach the 10 clips and remove the trim board. Then disconnect the connector.



e.
B165654E03
2.667,1.625 2.688,1.938 2.688,1.938 2.177,1.938 false 2.323,0.99 2.792,0.167 2.792,0.167 2.417,0.167 false 0.938,0.083 2.573,0.365 1.635,0.281 10 false End Cap (Color: White) 0.74,1.854 2.156,2.167 1.417,0.313 10 true End Cap (Color: Green)

Disconnect the 2 cables from the inside handle.


f.

Remove the inside handle.


Hide 86160Y 9.REMOVE REAR NO. 2 SPEAKER ASSEMBLY (for 12 Speakers)

Hide 68174A 10.REMOVE REAR INNER DOOR GLASS WEATHERSTRIP LH

Hide 67626C 11.REMOVE REAR NO. 2 DOOR TRIM BRACKET

a.
B169255

Remove the 2 screws and bracket.


Hide 67842E 13.REMOVE REAR DOOR SERVICE HOLE COVER LH

a.
B169256

Disconnect the connector and 5 clamps.


b.

Remove the rear door service hole cover.

HINT:

Remove the remaining tape on the door.



Hide 68152C 14.REMOVE REAR DOOR GLASS RUN LH

a.
B169257

Remove the rear door glass run.


Hide 67408F 15.REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH

a.
B169259

Remove the 2 bolts and rear door rear lower window frame.

HINT:

Remove the frame through the service hole.


NOTICE:

Be careful when removing the bolts as the frame may fall and become damaged.



Hide 68104 16.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

B169260

a.

Temporarily install the power window regulator switch.


b.

Move the door glass until the bolts appear in the service holes.


c.

Remove the 2 bolts.

NOTICE:

Be careful when removing the bolts as the glass may fall and become damaged.



d.

Remove the rear door glass from the rear door window regulator as shown in the illustration.

NOTICE:

Do not damage the door glass.



e.

Remove the power window regulator switch.


Hide 67406B 17.REMOVE REAR DOOR FRONT WINDOW GUIDE SUB-ASSEMBLY LH

a.
B169261

Remove the 2 bolts and rear lower front door window guide.

HINT:

Remove the frame through the service hole.


NOTICE:

Be careful when removing the bolts as the frame may fall and become damaged.



Hide 68192B 18.REMOVE REAR NO. 2 DOOR GLASS RUN LH

a.

Remove the rear door glass run from the rear front lower door window guide.


Hide 68163 19.REMOVE REAR OUTER DOOR GLASS WEATHERSTRIP

Hide 69804 20.REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

a.
B169262E03
2.781,1.208 1.583,0.479 1.583,0.479 1.292,0.479 false 0.313,0.406 1.281,0.781 0.969,0.375 10 true Temporary Bolt

Disconnect the connector.


b.

Loosen the temporary bolt.

NOTICE:

Do not remove the temporary bolt. If the temporary bolt is removed, the front door window regulator may fall and become damaged.



c.

Remove the 5 bolts and window regulator.


d.

Remove the window regulator through the service hole.


e.

Remove the temporary bolt from the door window regulator.


Hide 85720D 21.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

a.
B165662

Using a T25 "TORX" driver, remove the 3 screws and motor.

NOTICE:

Be careful when removing the screws as the motor may fall and become damaged.



Hide 69060A 22.REMOVE REAR DOOR LOCK ASSEMBLY LH

a.
B169263

Disconnect the connector.


b.

Using a T30 "TORX" wrench, remove the 3 screws and door lock.

HINT:

Remove the door lock through the service hole.


NOTICE:

Be careful when removing the bolts as the door lock may fall and become damaged.



Hide 69740D 23.REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

a.
B169265

Using a screwdriver, detach the claw.


b.
B169264E02
2.031,1.031 2.031,1.5 false 1.396,1.51 2.771,1.854 1.375,0.344 10 true End Cap (Color: Blue)

Remove the rear door lock remote control cable.


Hide 69780B 24.REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH

a.
B167681

Using a screwdriver, detach the 3 claws.

HINT:

Tape the screwdriver tip before use.



b.
B167682E02
1.927,0.552 2.073,0.552 2.073,0.552 2.219,1.135 false 0.406,0.49 1.906,0.854 1.5,0.365 10 true End Cap (Color: Yellow)

Remove the rear door inside locking cable.


Hide 67836H 25.REMOVE REAR DOOR LOCK CHILD PROTECTION COVER LH

Hide 69227L 26.REMOVE REAR DOOR OUTSIDE HANDLE COVER LH

a.
B170110

Remove the hole plug.


b.

Using a T30 "TORX" wrench, loosen the screw and remove the rear door outside handle cover.


c.

Remove the cover.


Hide 69240 27.REMOVE REAR DOOR OUTSIDE HANDLE ASSEMBLY LH

a.
B169268

Remove the handle by sliding and pulling it in the direction indicated by the arrow in the illustration.

NOTICE:

If the release plate is not pulled and held when removing the handle, the release plate will interfere with the handle and become damaged.



Hide 69204A 28.REMOVE REAR DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY LH

a.
B169266

Remove the front and rear outside handle pads .


b.

Using a T30 "TORX" wrench, loosen the screw.


c.

Slide the outside handle frame to remove it.

HINT:

Remove the outside handle frame through the service hole.



Hide 69332 29.REMOVE REAR DOOR LOCK OPEN ROD LH

a.

Remove the lock open rod from the outside handle frame.


Hide 67888A 30.REMOVE REAR NO. 2 DOOR WEATHERSTRIP LH

a.
B169269

Using a clip remover, detach the 10 clips and remove the weatherstrip.

HINT:

If clips are damaged during removal, replace them.



Hide 68640A 31.REMOVE REAR DOOR CHECK ASSEMBLY LH

a.
B166256

Remove the bolt, 2 nuts and door check.

HINT:

Remove the door check through the service hole.


NOTICE:

Be careful when removing the bolts as the door check may fall and become damaged.



Hide 67872 32.REMOVE REAR DOOR WEATHERSTRIP LH

a.
B170112

Using a clip remover, detach the 2 clips.


b.
B169270

Using a clip remover, detach the 41 clips and remove the weatherstrip.

HINT:

If clips are damaged during removal, replace them.