Connecting terminals TC and CG of the DLC3 causes the system to enter self-diagnostic mode. If a malfunction is present, DTCs will be output.
When a particular warning light remains blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in the relevant ECU is suspected.
Disconnect the A24 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J17-13 (TC) - A24-16 (TC) | Always | Below 1 Ω |
| J17-4 (CG) - Body ground | ||
| J17-13 (TC) - Body ground | Always | 10 kΩ or higher |
OK
NG