Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM
RM27M0U _51 Engine / Hybrid System _049139 CRUISE CONTROL _0234343 CRUISE CONTROL SYSTEM D

CRUISE CONTROL  CRUISE CONTROL SYSTEM  ROAD TEST  


PROBLEM SYMPTOM CONFIRMATION


a.
E337688

Inspect the SET function.

i.
E282302E01
0.08,0.171 2.347,0.401 2.267,0.230 12 Cruise Control Indicator Light: 0.08,1.815 2.755,2.045 2.674,0.230 12 Cruise Control SET Indicator Light:

Turn the main switch ON.


ii.

Check that the cruise control indicator light illuminates on the combination meter assembly.


iii.

Drive at the required speed (between approximately 40 km/h (25 mph) and 200 km/h (125 mph)).


iv.

Push the cruise control main switch to SET / COAST.


v.

Check that the cruise control SET indicator light illuminates at this time.


vi.

After releasing the switch, check that the vehicle cruises at the set speed.



b.
E337689

Inspect the ACCELERATION function.

i.

Turn the main switch ON.


ii.

Drive at the required speed (between approximately 40 km/h (25 mph) and 200 km/h (125 mph)).


iii.

Push the cruise control main switch to SET / COAST.


iv.

Check that vehicle speed increases while the cruise control main switch is pushed to RES / ACC, and that the vehicle cruises at the newly set speed when the switch is released.


v.

Momentarily push the cruise control main switch to RES / ACC and then immediately release it. Check that vehicle speed increases by approximately 1.6 km/h (1.0 mph) (tap-up control).



c.
E337688

Inspect the COAST function.

i.

Turn the main switch ON.


ii.

Drive at the required speed (between approximately 40 km/h (25 mph) and 200 km/h (125 mph)).


iii.

Push the cruise control main switch to SET / COAST.


iv.

Check that vehicle speed decreases while the cruise control main switch is pushed to SET / COAST, and that the vehicle cruises at the newly set speed when the switch is released.


v.

Momentarily push the cruise control main switch to SET / COAST, and then immediately release it. Check that vehicle speed decreases by approximately 1.6 km/h (1.0 mph) (tap-down control).



d.
E337690

Inspect the CANCEL function.

i.

Turn the main switch ON.


ii.

Drive at the required speed (between approximately 40 km/h (25 mph) and 200 km/h (125 mph)).


iii.

Push the cruise control main switch to SET / COAST.


iv.

When performing one of the following, check that the cruise control system is canceled and that the normal driving mode is reset.

·

Depressing the brake pedal.

·

Moving the shift lever from D to N.

·

With the shift lever on S, shifting to 1st, 2nd or 3rd gear.

·

Turning the main switch OFF.

·

Pulling the cruise control main switch to CANCEL.

·

Operating the VSC system.




e.
E337689

Inspect the RES (RESUME) function.

i.

Turn the main switch ON.


ii.

Drive at the required speed (between approximately 40 km/h (25 mph) and 200 km/h (125 mph)).


iii.

Push the cruise control main switch to SET / COAST.


iv.

Cancel the cruise control system according to any of the above operations (other than turning the main switch OFF).


v.

After pushing the cruise control main switch to RES / ACC at a driving speed of more than 40 km/h (25 mph), check that the vehicle drives at the set speed.