Home › Audio / Visual / Telematics › GARAGE DOOR OPENER › GARAGE DOOR OPENER SYSTEM
RM27M0U _56 Audio / Visual / Telematics _049142 GARAGE DOOR OPENER _0234355 GARAGE DOOR OPENER SYSTEM G

GARAGE DOOR OPENER  GARAGE DOOR OPENER SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT GARAGE DOOR OPENER

a.
B165760E03
0.899,1.802 1.076,1.944 0.176,0.142 10 *2 2.067,0.688 2.396,0.863 0.330,0.175 10 *1 1.604,1.538 1.94,0.768 1.94,0.768 2.043,0.768 false 1.705,1.65 1.705,1.896 1.705,1.896 1.095,1.896 false 1.407,1.62 1.407,1.896 false 1.278,1.61 1.278,1.896 false

Press each switch and check that the red LED turns on. If one or more of the switches does not turn on the LED, confirm normal operation of the fuse and wire harness. If the fuse and wire harness are malfunctioning, replace them. If not, replace the garage door opener.

Text in Illustration
*1 LED
*2 These Switches


Hide 2.INSPECT GARAGE DOOR OPENER REGISTRATION AND TRANSMITTING

HINT:

Use the "HomeLink" tester and a tester transmitter for this test. First erase the customer's transmitter code, and then register the tester transmitter code.


a.
B166263E03
2.539,0.045 2.720,0.210 0.181,0.165 10 *1 2.863,1.152 2.863,0.145 2.863,0.145 2.73,0.145 false

Check if the tester transmitter code was successfully registered.

HINT:

If the code cannot be registered, replace the garage door opener.


Text in Illustration
*1 Original Transmitter
V100135

Press


b.

Press the garage door opener switch that was registered to the tester transmitter. Check if the "HomeLink" tester's green LED illuminates.

B355358E01
0.041,0.11 0.262,0.303 0.221,0.193 12 *A 3.67,0.11 3.891,0.303 0.221,0.193 12 *B 2.956,3.361 3.158,3.528 0.202,0.167 10 *1 2.603,3.436 2.937,3.436 false 6.428,3.344 6.630,3.512 0.202,0.167 10 *1 6.075,3.419 6.409,3.419 false

Text in Illustration
*A for Column Shift *2 for Floor Shift
*1 "HOME LINK" Tester - -
V100135

Press - -

HINT:

If the green LED does not illuminate, replace the garage door opener.



c.

When the inspection is complete, reregister the customer's transmitter code(s) again.