Home › Engine / Hybrid System › 3UR-FE STARTING › STARTER
RM27M0U _51 Engine / Hybrid System _049143 3UR-FE STARTING _0234357 STARTER A

3UR-FE STARTING  STARTER  DISASSEMBLY  


PROCEDURE

Hide 28150 1.REMOVE MAGNET STARTER SWITCH ASSEMBLY

a.
A258303

Remove the nut and disconnect the lead wire from the magnet starter switch.


b.
A258304

Remove the 2 nuts from the starter drive housing while holding the magnet starter switch.


c.
A259098

Pull the magnet starter switch and while lifting the front part of the magnet starter switch, release the plunger hook from the drive lever and remove the magnet starter switch.


Hide 28120 2.REMOVE STARTER YOKE ASSEMBLY

a.
A258305

Using a T25 "TORX" socket wrench, remove the 2 bolts.


b.

Pull out the starter yoke together with the starter commutator end frame.


c.
A259102

Remove the 2 screws and starter commutator end frame from the starter yoke.

NOTICE:

While holding down the lead wire, remove the starter commutator end frame.



Hide 28140 3.REMOVE STARTER BRUSH HOLDER ASSEMBLY

a.
A215969

Using a screwdriver, pry the end of the spring away from each brush and pull out the 4 brushes from the brush holder so that they are held in place by the springs.


b.

Remove the starter brush holder.


Hide 28160 4.REMOVE STARTER ARMATURE ASSEMBLY

a.
A262992

Remove the starter armature from the starter yoke.


Hide 28021 5.REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY

a.
A258323

Remove the starter armature plate from the starter center bearing clutch or starter yoke.


b.
A258324

Remove the 3 planetary gears from the starter center bearing clutch.


c.
A258325E03
2.021,2.229 1.417,0.49 1.417,0.49 1.281,0.49 false 2,0.656 2.208,0.115 2.208,0.115 2.333,0.115 false 2.771,1.24 2.656,1.479 2.656,1.479 2.656,1.573 false 0.375,0.396 1.354,0.74 0.979,0.344 10 false Starter Center Bearing Clutch 2.396,0.042 3.271,0.365 0.875,0.323 10 false Starter Pinion Drive Lever 2.208,1.573 3.021,1.729 0.813,0.156 10 false Rubber Seal

Remove the starter center bearing clutch together with the starter pinion drive lever and rubber seal from the starter drive housing.


d.

Remove the starter pinion drive lever and rubber seal from the starter center bearing clutch.