Home › Engine / Hybrid System › 1UR-FE STARTING › ACC CUT RELAY
RM27M0U _51 Engine / Hybrid System _049144 1UR-FE STARTING _0234366 ACC CUT RELAY G

1UR-FE STARTING  ACC CUT RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.REMOVE ACC CUT RELAY

a.

Remove the clip.


b.

Detach the 2 clips and remove the cowl side trim board RH.


c.

Remove the relay.


Hide 2.INSPECT ACC CUT RELAY

a.
A087121E35
2.354,0.604 2.354,0.292 false 2.49,1.115 2.958,1.115 false 2.49,1.615 2.958,1.615 false 2.042,0.604 1.865,0.292 false 2.635,0.604 2.813,0.292 false 0.354,1.427 0.552,1.635 0.198,0.208 10 false 1 1.792,0.115 1.99,0.323 0.198,0.208 10 false 1 1.302,1.427 1.5,1.635 0.198,0.208 10 false 2 2.813,0.094 3.01,0.302 0.198,0.208 10 false 2 0.365,0.885 0.563,1.094 0.198,0.208 10 false 3 3,1.531 3.198,1.74 0.198,0.208 10 false 3 0.958,0.427 1.156,0.635 0.198,0.208 10 false 4 2.323,0.104 2.521,0.313 0.198,0.208 10 false 4 1.302,0.885 1.5,1.094 0.198,0.208 10 false 5 3,1.031 3.198,1.24 0.198,0.208 10 false 5

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester connection Condition Specified Condition
3 - 4 When battery voltage is not applied to terminals 1 and 2 Below 1 Ω
When battery voltage is applied to terminals 1 and 2 10 kΩ or higher


If the result is not as specified, replace the relay.


Hide 3.INSTALL ACC CUT RELAY

a.

Install the relay.


b.

Attach the 2 clips to install the cowl side trim board RH.


c.

Install the clip.