1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
3.REMOVE STEERING COLUMN ASSEMBLY
for Manual Tilt: (See page Steering>STEERING COLUMN>STEERING COLUMN ASSEMBLY(for Manual Tilt)>REMOVAL)
for Manual Tilt and Manual Telescopic Steering Column: (See page Steering>STEERING COLUMN>STEERING COLUMN ASSEMBLY(for Manual Tilt and Manual Telescopic Steering Column)>REMOVAL)
45020
4.REMOVE UPPER STEERING COLUMN WITH SWITCH BRACKET ASSEMBLY (for Manual Tilt)
45020
5.REMOVE UPPER STEERING COLUMN WITH SWITCH BRACKET ASSEMBLY (for Manual Tilt and Manual Telescopic Steering Column)
84450
6.REMOVE IGNITION SWITCH ASSEMBLY
Detach the 2 claws and remove the ignition switch from the steering lock.