Home › Engine / Hybrid System › 1UR-FE STARTING › STARTER(for 1.6 kW Type)
RM27M0U _51 Engine / Hybrid System _049144 1UR-FE STARTING _0234368 STARTER(for 1.6 kW Type) A

1UR-FE STARTING  STARTER(for 1.6 kW Type)  DISASSEMBLY  


PROCEDURE

Hide 28150 1.REMOVE MAGNET STARTER SWITCH ASSEMBLY

a.
A215952

Remove the nut and disconnect the lead wire from the magnet starter switch.


b.
A215953

Remove the 2 nuts from the starter drive housing while holding the magnet starter switch.


c.
A215954

Pull the magnet starter switch and while lifting the front part of the magnet starter switch, release the plunger hook from the drive lever and remove the magnet starter switch.


Hide 28120 2.REMOVE STARTER YOKE ASSEMBLY

a.
A215955

Using a T25 "TORX" socket wrench, remove the 2 bolts.


b.
A215956

Pull out the starter yoke together with the starter commutator end frame.


c.
A215957

Remove the 2 screws and commutator end frame from the starter yoke.


d.
A215970

Pull the starter yoke out of the starter commutator end frame.

NOTICE:

While holding down the lead wire, remove the starter commutator end frame.



Hide 28140 3.REMOVE STARTER BRUSH HOLDER ASSEMBLY

a.
A215969

Using a screwdriver, pry the end of the spring away from each brush and pull out the 4 brushes from the brush holder so that they are held in place by the springs.


b.

Remove the brush holder.


Hide 28160 4.REMOVE STARTER ARMATURE ASSEMBLY

a.
A215959

Remove the starter armature from the starter yoke.


Hide 28177 5.REMOVE STARTER ARMATURE PLATE

a.
A215974

Remove the starter armature plate from the starter drive housing or starter yoke.


Hide 28255 6.REMOVE PLANETARY GEAR

a.
A215962

Remove the 3 planetary gears from the starter center bearing clutch.


Hide 28021 7.REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY

a.
A215960E02
2.344,0.094 2.25,0.094 2.25,0.094 1.979,0.333 false 2.396,1.146 2.302,1.146 2.302,1.146 2.333,1.042 false 1.156,1.354 1.26,1.354 1.26,1.354 1.667,1.521 false 2.438,1.063 3.25,1.219 0.813,0.156 10 false Rubber Seal 2.365,0.021 3.229,0.333 0.865,0.313 10 false Starter Pinion Drive Lever 0.271,1.271 1.24,1.604 0.969,0.333 10 true Starter Center Bearing Clutch

Remove the starter center bearing clutch with the starter pinion drive lever and rubber seal from the starter drive housing.


b.

Remove the starter pinion drive lever and rubber seal from the starter center bearing clutch.