Home › Engine / Hybrid System › 3UR-FBE STARTING › STARTER RELAY
RM27M0U _51 Engine / Hybrid System _049145 3UR-FBE STARTING _0234371 STARTER RELAY G

3UR-FBE STARTING  STARTER RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.REMOVE STARTER RELAY (ST)

a.

Remove the engine room relay box cover.


b.

Remove the starter relay from the engine room relay block.


Hide 2.INSPECT STARTER RELAY

a.
A379977E01
2,0.719 1.781,0.344 false 2.656,0.688 2.885,0.302 false 2.531,1.115 2.927,1.115 false 2.542,1.615 2.938,1.615 false 0.26,0.771 0.385,0.938 0.125,0.167 10 false 5 0.271,1.292 0.365,1.438 0.094,0.146 10 false 1 1.188,0.76 1.271,0.938 0.083,0.177 10 false 3 1.177,1.292 1.26,1.469 0.083,0.177 10 false 2 1.698,0.188 1.781,0.365 0.083,0.177 10 false 1 2.906,0.156 2.99,0.333 0.083,0.177 10 false 2 2.969,1.031 3.052,1.208 0.083,0.177 10 false 5 2.969,1.542 3.052,1.719 0.083,0.177 10 false 3

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Terminal Connection Condition Specified Condition
3 - 5 When battery voltage is not applied to terminals 1 and 2 10 kΩ or higher
When battery voltage is applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the relay.


Hide 3.INSTALL STARTER RELAY