1.REMOVE ACC CUT RELAY
Remove the clip.
Detach the 2 clips and remove the cowl side trim board RH.
Remove the relay.
2.INSPECT ACC CUT RELAY
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 4 | When battery voltage is not applied to terminals 1 and 2 | Below 1 Ω |
| When battery voltage is applied to terminals 1 and 2 | 10 kΩ or higher |
If the result is not as specified, replace the relay.
3.INSTALL ACC CUT RELAY
Install the relay.
Attach the 2 clips to install the cowl side trim board RH.
Install the clip.