37100
1.REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
Place matchmarks on the propeller shaft flange and differential flange.
| *a | Matchmark |
Remove the 4 bolts and 4 nuts. Then disconnect the propeller shaft from the differential side.
w/o Bearing Washer:
Remove the 2 mounting bolts from the crossmember.
w/ Bearing Washer:
Remove the 2 mounting bolts and 2 bearing washers from the crossmember.
Remove the propeller shaft.
for 1UR-FE:
Insert SST into the transmission to prevent oil leakage.
| *A | for 1UR-FE |
for 3UR-FE:
Insert SST into the transmission to prevent oil leakage.
| *A | for 3UR-FE |