Home › Drivetrain › PROPELLER SHAFT › FRONT PROPELLER SHAFT ASSEMBLY
RM27M0U _52 Drivetrain _049149 PROPELLER SHAFT _0234384 FRONT PROPELLER SHAFT ASSEMBLY A

PROPELLER SHAFT  FRONT PROPELLER SHAFT ASSEMBLY  DISASSEMBLY  


PROCEDURE

Hide 37401D 1.REMOVE FRONT PROPELLER SHAFT JOINT SPIDER BEARING SNAP RING

a.
C158560E04
2.206,0.043 2.380,0.188 0.174,0.146 10 *a 1.414,0.641 2.167,0.215 2.167,0.215 1.656,0.751 false

Place matchmarks on the flange yoke.

Text in Illustration
*a Matchmark


b.
C158561

Using a brass bar and hammer, slightly tap in the spider bearing outer races.


c.

Using needle-nose pliers, remove the 4 snap rings from the grooves.


Hide 37401D 2.REMOVE SPIDER BEARING

F015025E23
1.229,0.74 0.354,0.74 false 2.51,1.167 2.188,1.417 false 0.063,0.667 0.365,0.833 0.302,0.167 10 false SST 2.073,1.354 2.219,1.563 0.146,0.208 10 true A

a.

Using SST, push out the bearing from the flange yoke.

SST
09332-25010  

HINT:

Before installing SST, sufficiently raise the part labeled A. If part A is too low, SST may be difficult to install.



b.
F044192E11
2.333,0.719 2.948,1.313 false 2.927,1.344 3.167,1.521 0.24,0.177 10 false *a

Clamp the spider bearing outer race in a vise and tap off the propeller shaft with a hammer.

Text in Illustration
*a Hammering Point

NOTICE:

Do not tap the shaft tube.


HINT:

Remove the bearing on the opposite side using the same procedure.



c.
F015030E19
2.563,1.063 2.177,1.313 false 0.646,1.115 0.938,1.115 false 2.052,1.271 2.167,1.406 0.115,0.135 10 false A 0.365,1.042 0.708,1.24 0.344,0.198 10 false SST

Install the 2 removed spider bearing outer races to the spider.


d.

Using SST, push the bearing out of the flange yoke.

SST
09332-25010  

HINT:

Before installing SST, sufficiently raise the part labeled A. If part A is too low, SST may be difficult to install.



e.
C158562E02
1.249,0.14 1.426,0.310 0.177,0.170 10 *a 1.464,0.226 1.851,0.226 false 1.851,0.226 2.381,0.579 false

Clamp the outer bearing race in a vise and tap off the flange yoke with a hammer.


f.

Remove the spider.

Text in Illustration
*a Hammering Point

HINT:

Remove the bearing on the opposite side using the same procedure.