Home › Suspension › SUSPENSION › FRONT SHOCK ABSORBER
RM27M0U _53 Suspension _049152 SUSPENSION _0234395 FRONT SHOCK ABSORBER N

SUSPENSION  FRONT SHOCK ABSORBER  DISPOSAL  


PROCEDURE

Hide 48520 1.DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY LH

a.

Fully extend the shock absorber rod.


b.
C159159E02
1.865,2.958 1.521,2.958 false 1.521,2.958 1.521,3.25 false 0.885,2.979 1.063,2.979 false 1.063,2.979 1.063,3.25 false 1.104,3.698 1.104,4.104 false 0.073,0.063 1.479,0.26 1.406,0.198 12 false for Standard Type: 0.083,2.406 1.771,2.604 1.688,0.198 12 false for Off-Road Package: 0.823,3.771 0.969,3.917 0.146,0.146 10 false A 0.979,1.677 1.125,1.823 0.146,0.146 10 false A 1.26,3.771 1.385,3.927 0.125,0.156 10 false B 1.729,1.667 1.854,1.823 0.125,0.156 10 false B 0.25,2.896 0.854,3.063 0.604,0.167 10 false Gas Area 1.927,2.875 2.469,3.052 0.542,0.177 10 false Oil Area 0.677,4.135 1.792,4.354 1.115,0.219 10 false 50 mm (1.969 in.)

Using a drill, make a hole in the cylinder between A and B shown in the illustration to discharge the gas inside.

CAUTION:
·

Be careful when drilling because shards of metal may fly about. Always use the proper safety equipment.

·

For off road type shock absorbers, be extremely careful when drilling it as its gas pressure is much higher than the standard type.



NOTICE:

The gas is colorless, odorless and nonpoisonous.