Home › Suspension › SUSPENSION › FRONT SHOCK ABSORBER
RM27M0U _53 Suspension _049152 SUSPENSION _0234395 FRONT SHOCK ABSORBER A

SUSPENSION  FRONT SHOCK ABSORBER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart (see page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 1.TEMPORARILY INSTALL FRONT SHOCK ABSORBER WITH COIL SPRING

C155965

a.

Temporarily install the upper side of the shock absorber to the chassis frame with the 4 nuts.


b.
C155964

Temporarily install the lower side of the shock absorber to the lower suspension arm with the bolt, washer and nut.


Hide 2.STABILIZE SUSPENSION

a.

Lower the vehicle.


b.

Press down on the vehicle several times to stabilize the suspension.


Hide 3.TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING

C155964

a.

Tighten the nut.

Torque:
195 N*m (1988 kgf*cm, 144 ft.*lbf)


b.
C163294E03
1.354,1.396 1.573,1.583 0.219,0.188 10 false 1,5 1.979,0.573 2.083,0.719 0.104,0.146 10 false 2 1.969,1.396 2.073,1.542 0.104,0.146 10 false 3 1.323,0.594 1.427,0.74 0.104,0.146 10 false 4

Tighten the 4 upper nuts in diametrically opposite pairs.

Torque:
45 N*m (459 kgf*cm, 33 ft.*lbf)


c.

Check that the first nut that was tightened is at the torque specification.


Hide 4.INSTALL FRONT WHEEL

Torque:
for Aluminum Wheel : 131 N*m (1336 kgf*cm, 97 ft.*lbf)
for Steel Wheel : 209 N*m (2131 kgf*cm, 154 ft.*lbf)