Home › Suspension › SUSPENSION › FRONT LOWER SUSPENSION ARM
RM27M0U _53 Suspension _049152 SUSPENSION _0234397 FRONT LOWER SUSPENSION ARM G

SUSPENSION  FRONT LOWER SUSPENSION ARM  INSPECTION  


PROCEDURE

Hide 48069 1.INSPECT FRONT NO. 1 SUSPENSION ARM LOWER SUB-ASSEMBLY LH

G021680

a.

As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut.


b.

Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn.

Standard turning torque:

3.0 to 10.0 N*m (31 to 102 kgf*cm, 27 to 89 in.*lbf)



c.

Check for any cracks and grease leaks on the ball joint dust cover.