Home › Suspension › SUSPENSION › REAR SHOCK ABSORBER
RM27M0U _53 Suspension _049152 SUSPENSION _0234399 REAR SHOCK ABSORBER A

SUSPENSION  REAR SHOCK ABSORBER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart (see page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 48540 1.TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH

a.

Install the 2 retainers and No. 3 cushion to the shock absorber.


b.
C159325

Temporarily install the shock absorber, cushion and retainer with the nut.


c.
C159333

Temporarily install the lower side of the shock absorber with the bolt and nut.


Hide 2.STABILIZE SUSPENSION

a.

Lower the vehicle.


b.

Press down on the vehicle several times to stabilize the suspension.


Hide 48540 3.TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH

a.

Tighten the bolt and 2 nuts.

Torque:
Upper side : 28 N*m (286 kgf*cm, 21 ft.*lbf)
Lower side : 90 N*m (918 kgf*cm, 66 ft.*lbf)


Hide 4.INSTALL REAR WHEEL

Torque:
for Aluminum Wheel : 131 N*m (1336 kgf*cm, 97 ft.*lbf)
for Steel Wheel : 209 N*m (2131 kgf*cm, 154 ft.*lbf)

Hide 5.REMOVE SAFETY STANDS