When the ignition switch is turned ON, positive (+) battery voltage is applied to the air conditioning amplifier.
Remove the ECU-IG1 No.4 fuse from the main body ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| ECU-IG1 No.4 fuse | Always | Below 1 Ω |
OK
NG
Disconnect the J19 air conditioning amplifier connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J19-14 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| J19-1 (IG+) - Body ground | Ignition switch ON | 11 to 14 V |
OK
NG