Home › Vehicle Interior › AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)
RM27M0U _58 Vehicle Interior _049154 AIR CONDITIONING _0234411 AIR CONDITIONING SYSTEM(for Manual Air Conditioning System) U

AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)  DATA LIST / ACTIVE TEST  


READ DATA LIST


HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Warm up the engine.


b.

Turn the ignition switch OFF.


c.

Connect the Techstream to the DLC3.


d.

Turn the ignition switch ON.


e.

Turn the Techstream on.


f.

Enter the following menus: ALL ECUs / (desired menu) / Data List.


g.

According to the display on tester, read the "Data List".

Air Conditioner
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Ambient Temp Sensor Ambient temperature sensor /
Min.: -23.3°C (-9.94°F)
Max.: 65.95°C (150.71°F)
Actual ambient temperature is displayed Open in circuit: -23.3°C (-9.94°F)
Short in circuit: 65.95°C (150.71°F)
Adjusted Ambient Temp Adjusted ambient temperature /
Min.: -30.8°C (-23.44°F)
Max.: 50.8°C (123.44°F)
Adjusted ambient temperature is displayed -
Evaporator Fin Thermistor No. 1 cooler thermistor /
Min.: -29.7°C (-21.46°F)
Max.: 59.55°C (139.19°F)
Actual No. 1 cooler thermistor is displayed Open in circuit: -29.7°C (-21.46°F)
Short in circuit: 59.55°C (139.19°F)
Engine Coolant Temp Engine coolant temperature /
Min.: 1.3°C (34.34°F)
Max.: 90.55°C (194.99°F)
Actual engine coolant temperature is displayed while engine is warmed up -
Air Mix Servo Targ Pulse (D) No. 1 damper servo sub-assembly (air mix servo motor) target pulse /
Min.: 0, Max.: 255
MAX. COLD: 5 (pulse)
MAX. HOT: 104 (pulse)
-
Air Outlet Servo Pulse (D) No. 1 damper servo sub-assembly (air outlet servo motor) target pulse /
Min.: 0, Max.: 255
FACE: 9 (pulse)
MID: 25 (pulse)
B/L: 32 (pulse)
MID: 39 (pulse)
FOOT: 56 (pulse)
MID: 77 (pulse)
FOOT/DEF: 83 (pulse)
MID: 91 (pulse)
DEF: 97 (pulse)
-
Air Inlet Damper Targ Pulse Air inlet damper target pulse /
Min.: 0, Max.: 255
REC: 7
FRS: 28
-
Ambient Temperature Shift Ambient temperature shift / 3C incr, 2C incr, 1C incr, Normal, 1C decr, 2C decr or 3C decr Customized value will be displayed -
Number of Trouble Codes Number of trouble codes /
Min.: 0, Max.: 255
Number of DTCs will be displayed -

Engine and ECT
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
A/C Signal A/C switch signal /
ON or OFF
ON: A/C switch ON
OFF: A/C switch OFF
-



PERFORM ACTIVE TEST


HINT:

Using the Techstream to perform the Active Tests allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch ON.


c.

Turn the Techstream on.


d.

Enter the following menus: Body Electrical / Air Conditioner / Active Test.


e.

According to the display on the Techstream, perform the "Active Test".

Air Conditioner
Tester Display Test Part Control Range Diagnostic Note
Magnetic Clutch Relay Magnetic clutch relay ON or OFF -
Defogger Relay (Rear) Defogger relay ON or OFF -
Mirror Heater Relay Mirror heater relay ON or OFF -
Deicer Relay (Front) Deicer relay ON or OFF -
Air Mix Servo Targ Pulse (D) No. 1 damper servo sub-assembly (air mix servo motor) pulse Min.: 5, Max.: 104 -
Air Outlet Servo Pulse (D) No. 1 damper servo sub-assembly (air outlet servo motor) pulse Min.: 9, Max.: 97 -
Air Inlet Damper Targ Pulse Air inlet damper target pulse Min.: 7, Max.: 28 -