Home › Vehicle Interior › AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)
RM27M0U _58 Vehicle Interior _049154 AIR CONDITIONING _0234412 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) C

AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  B1423/23  Pressure Sensor Circuit  


DESCRIPTION

This DTC is output when refrigerant pressure is extremely low (196 kPa (2.0 kgf/cm2, 28 psi) or less) or extremely high (3140 kPa (32.0 kgf/cm2, 455 psi) or more). The pressure switch, which is installed on the pipe of the high pressure side to detect refrigerant pressure, outputs a refrigerant pressure signal to the air conditioning amplifier.

The air conditioning amplifier controls the compressor according to the sensor characteristic.

HINT:

Be sure to check the refrigerant volume first when this DTC is output because this DTC can also be output if there is no refrigerant in the system.


DTC Code DTC Detection Condition Trouble Area
B1423/23 Open or short in pressure switch circuit
·

Air conditioning pressure switch

·

Harness or connector

·

Air conditioning amplifier



WIRING DIAGRAM

B159038E11
4.78,1.54 6.471,1.698 1.691,0.158 10 J19 4.738,1.063 6.429,1.221 1.691,0.158 10 PSW 4.472,0.909 4.603,1.067 0.131,0.158 10 9 2.945,0.909 3.076,1.067 0.131,0.158 10 1 2.02,0.909 2.151,1.067 0.131,0.158 10 2 4.78,1.722 6.471,1.880 1.691,0.158 10 Air Conditioning Amplifier 1.796,1.351 2.146,1.509 0.350,0.158 10 A20 1.796,1.533 3.917,1.691 2.121,0.158 10 Air Conditioning Pressure Switch 2.286,1.164 2.477,1.322 0.190,0.158 10 -S 2.651,1.157 2.882,1.315 0.231,0.158 10 +S

CAUTION / NOTICE / HINT

HINT:

Be sure to check the refrigerant volume first when this DTC is output because this DTC can also be output if there is no refrigerant in the system.


PROCEDURE

1.CHECK HARNESS OR CONNECTOR (AIR CONDITIONING PRESSURE SWITCH - AIR CONDITIONING AMPLIFIER AND BODY GROUND)
U152759E01
0.313,0.082 2.728,0.441 2.415,0.360 10 Front view of wire harness connector:(to Air Conditioning Pressure Switch) 0.313,2.226 2.728,2.586 2.415,0.360 10 Rear view of wire harness connector:(to Air Conditioning Amplifier) 0.562,1.265 0.843,1.428 0.281,0.163 10 A20 0.73,3.891 1.011,4.054 0.281,0.163 10 J19 2.212,4.338 2.587,4.490 0.375,0.152 10 PSW 2.022,3.951 2.4,4.329 false 0.919,1.866 1.113,2.029 0.194,0.163 10 +S 2.311,1.866 2.592,2.029 0.281,0.163 10 -S 1.138,1.935 1.559,1.574 false 1.912,1.591 2.261,1.968 false

a.

Disconnect the A20 air conditioning pressure switch connector.


b.

Disconnect the J19 air conditioning amplifier connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard resistance:
Tester Connection Condition Specified Condition
A20-1 (+S) - J19-9 (PSW) Always Below 1 Ω
A20-1 (+S) or J19-9 (PSW) - Body ground Always 10 kΩ or higher
A20-2 (-S) - Body ground Always Below 1 Ω




OK

2.CHECK AIR CONDITIONING PRESSURE SWITCH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK AIR CONDITIONING PRESSURE SWITCH
a.

Set the manifold gauge set.


E146630E02
0.745,1.687 1.039,1.354 false 0.63,1.687 0.336,1.354 false 0.181,1.155 0.574,1.300 0.393,0.146 10 2 (-S) 0.858,1.164 1.303,1.310 0.445,0.146 10 1 (+S)

b.

Disconnect the A20 air conditioning pressure switch connector.


c.

Run the engine at approximately 2000 rpm.


d.

Set the blower speed control switch to the HI position.


e.

Set the temperature control level to the MAX. COOL position.


f.

Turn the A/C switch ON.


g.

Check the switch operation.

i.

Connect the positive (+) lead from an ohmmeter to terminal 1 (+S) and the negative (-) lead to terminal 2 (-S).


ii.

Measure the resistance between the terminals when refrigerant pressure is changed as shown in the illustration.

E146631E01
2.05,0.318 3.229,0.641 1.179,0.323 10 Low pressure side 3.949,0.318 5.171,0.494 1.223,0.176 10 High pressure side 4.516,0.934 5.519,1.111 1.003,0.177 10 ON (Continuity) 1.032,1.499 2.327,1.676 1.295,0.177 10 OFF (No Continuity) 4.887,1.499 6.182,1.676 1.295,0.177 10 OFF (No Continuity) 2.729,1.607 3.266,1.798 0.538,0.191 10 196 kPa 3.895,1.607 4.572,1.798 0.677,0.191 10 3140 kPa 2.224,1.98 3.540,2.164 1.316,0.184 10 (2.0 kgf/cm2, 28 psi) 3.731,1.98 5.470,2.164 1.738,0.184 10 (32.0 kgf/cm2, 455 psi)

OK:

Resistance varies as shown in the illustration.


Result
Result Proceed to
NG A
OK (Checking from the PROBLEM SYMPTOMS TABLE) B
OK (Checking from the DTC) C




A

REPLACE AIR CONDITIONING PRESSURE SWITCH

B

C

REPLACE AIR CONDITIONING AMPLIFIER