Home › Vehicle Interior › AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)
RM27M0U _58 Vehicle Interior _049154 AIR CONDITIONING _0234412 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) J

AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  IG Power Source Circuit  


DESCRIPTION

When the ignition switch is turned ON, positive (+) battery voltage is applied to the air conditioning amplifier.

WIRING DIAGRAM

E146515E12
4.524,0.583 4.708,0.785 0.184,0.202 10 1 4.468,1.423 4.652,1.625 0.184,0.202 10 14 4.759,0.683 5.080,0.866 0.321,0.184 10 IG+ 4.763,1.535 5.179,1.719 0.416,0.184 10 GND 4.496,1.916 4.819,2.100 0.323,0.184 10 J19 4.496,2.098 6.180,2.282 1.684,0.184 10 Air Conditioning Amplifier 0.264,0.672 1.633,0.883 1.369,0.211 10 from IG No.1 Relay 2.017,0.572 2.951,0.812 0.934,0.239 10 ECU-IG1 No.4

PROCEDURE

1.INSPECT FUSE (ECU-IG1 No.4)
a.

Remove the ECU-IG1 No.4 fuse from the main body ECU.


b.

Measure the resistance according to the value(s) in the table below.

Standard resistance:
Tester Connection Condition Specified Condition
ECU-IG1 No.4 fuse Always Below 1 Ω




OK

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY AND BODY GROUND)

NG

REPLACE FUSE

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY AND BODY GROUND)
U152752E02
2.51,2.448 2.854,2.885 false 1.708,2.448 1.365,2.906 false 0.26,0.469 2.531,0.833 2.271,0.365 10 false Rear view of wire harness connector: (to Air Conditioning Amplifier) 0.708,2.427 0.99,2.646 0.281,0.219 10 false J19 1.167,2.938 1.573,3.115 0.406,0.177 10 false GND 2.813,2.917 3.094,3.115 0.281,0.198 10 false IG+

a.

Disconnect the J19 air conditioning amplifier connector.


b.

Measure the resistance and voltage according to the value(s) in the table below.

Standard resistance:
Tester Connection Condition Specified Condition
J19-14 (GND) - Body ground Always Below 1 Ω


Standard voltage:
Tester Connection Switch Condition Specified Condition
J19-1 (IG+) - Body ground Ignition switch ON 11 to 14 V




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR