89120A
1.INSPECT AUTOMATIC LIGHT CONTROL SENSOR (SOLAR SENSOR)
Connect the positive (+) lead from the battery to terminal 6 and the negative (-) lead to terminal 3, and then measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (TSL) - 3 (CLTE) | Sensor subjected to electric light | 0.8 to 4.3 V |
| Sensor covered with a cloth | 0.8 V or less | |
| 2 (TSR) - 3 (CLTE) | Sensor subjected to electric light | 0.8 to 4.3 V |
| Sensor covered with a cloth | 0.8 V or less |
As the inspection light is moved away from the sensor, the voltage decreases.
Use an incandescent light for inspection. Bring it within 30 cm (11.8 in.) of the solar sensor.
| *a | Component without harness connected
(Automatic Light Control Sensor (Solar Sensor)) |
If the result is not as specified, replace the automatic light control sensor (solar sensor).