85934
1.INSPECT MAGNETIC CLUTCH RELAY (MG CLT)
Remove the magnetic clutch relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage is not applied between terminals | 10 kΩ or higher |
| Battery voltage is applied to terminals 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the magnet clutch relay.
Install the magnetic clutch relay to the engine room relay block.