88320
1.INSPECT COOLER COMPRESSOR ASSEMBLY
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (SSR+) - 2 (SSR-) | 20°C (68°F) | 65 to 125 Ω |
| *a | Component without harness connected
(Magnet Clutch Assembly) |
If the resistance is not as specified, replace the cooler compressor assembly.
88410
2.INSPECT MAGNET CLUTCH ASSEMBLY
Confirm that the magnet clutch hub and magnet clutch rotor lock when the battery positive lead is connected to terminal 3 of the magnet clutch, and the negative lead is connected to the ground wire.
| *1 | Battery |
| *2 | Magnet Clutch Rotor |
| *3 | Magnet Clutch Hub |
| *a | Component without harness connected
(Magnet Clutch Assembly) |
If the operation is not as specified, replace the magnet clutch assembly.