1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
53737B
2.REMOVE FRONT FENDER APRON SEAL LH
Remove the 6 clips and front fender apron seal LH.
16361A
3.REMOVE FAN AND GENERATOR V BELT
for 1UR-FE: (See page Engine / Hybrid System>1UR-FE ENGINE MECHANICAL>DRIVE BELT>REMOVAL)
for 3UR-FE: (See page Engine / Hybrid System>3UR-FE ENGINE MECHANICAL>DRIVE BELT>REMOVAL)
for 3UR-FBE: (See page Engine / Hybrid System>3UR-FBE ENGINE MECHANICAL>DRIVE BELT>REMOVAL)
88711
4.DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the cooler compressor assembly.
Remove the O-ring from the No. 1 cooler refrigerant discharge hose.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
88712
5.DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE
Remove the bolt and disconnect the No. 1 cooler refrigerant suction hose from the cooler compressor assembly.
Remove the O-ring from the No. 1 cooler refrigerant suction hose.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
88320
6.REMOVE COOLER COMPRESSOR ASSEMBLY
Disconnect the connector.
Remove the 2 bolts and 2 nuts.
Remove the 2 stud bolts and cooler compressor assembly.