Home › Vehicle Interior › THEFT DETERRENT › THEFT DETERRENT SYSTEM
RM27M0U _58 Vehicle Interior _049155 THEFT DETERRENT _0234426 THEFT DETERRENT SYSTEM U

THEFT DETERRENT  THEFT DETERRENT SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch ON.


c.

Turn the Techstream on.


d.

Enter the following menus: Body Electrical / Main Body / Data List.


e.

According to the display on the Techstream, read the "Data List".

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Hood Courtesy Switch Engine hood courtesy switch / ON or OFF ON: Engine hood is open
OFF: Engine hood is closed
-
IG SW Ignition switch / ON or OFF ON: Ignition switch ON
OFF: Ignition switch off
-
Glass Break Sensor Detection* Glass breakage sensor detection / ON or OFF ON: Glass breakage sensor ON
OFF: Glass breakage sensor OFF
-

HINT:

*: w/ Glass Breakage Sensor




ACTIVE TEST


HINT:

Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch ON.


c.

Turn the Techstream on.


d.

Enter the following menus: Body Electrical / (desired system) /Active Test.


e.

According to the display on the Techstream, perform the "Active Test".

Main body
Tester Display Test Part Control Range Diagnostic Note
Security Horn Security horn ON/OFF -
Security Indicator Security indicator ON/OFF -

Immobiliser
Tester Display Test Part Control Range Diagnostic Note
Security Indicator Security indicator ON/OFF -