CHECK COMBINATION METER
Measure the resistance and voltage according to the value(s) in the table below.
| Terminal No. (Symbols) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| J28-1 (B) - Body ground | LG - Body ground | Power source | Always | 11 to 14 V |
| J28-2 (IG+) - Body ground | P - Body ground | Ignition switch signal | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V | |||
| J28-3 (BZ) - Body ground*1 | V - Body ground | Clearance warning buzzer | Clearance warning buzzer sounding (when the back sonar or clearance sonar sensors something) | Pulse generation |
| J28-4 (BK) - Body ground*1 | BE - Body ground | Ultrasonic sensor (for rear corner LH and RH) | Clearance warning indicator for back right and left sensor illuminates | Below 3 V |
| J28-5 (OP) - Body ground*1 | R - Body ground | Clearance warning ECU signal | Clearance warning indicator's operation indicator illuminates | Below 3 V |
| J28-6 (FR) - Body ground*1 | B - Body ground | Ultrasonic sensor (for front corner RH) | Clearance warning indicator for front corner RH illuminates | Below 3 V |
| J28-7 (FL) - Body ground*1 | LG - Body ground | Ultrasonic sensor (for front corner LH) | Clearance warning indicator for front corner LH illuminates | Below 3 V |
| J28-8 (RR) - Body ground*1 | G - Body ground | Ultrasonic sensor (for rear corner RH) | Clearance warning indicator for rear corner RH illuminates | Below 3 V |
| J28-9 (RL) - Body ground*1 | GR - Body ground | Ultrasonic sensor (for rear corner LH) | Clearance warning indicator for rear corner LH illuminates | Below 3 V |
| J28-10 (CHK) - Body ground | R - Body ground | MIL input signal | Ignition switch ON, MIL ON | Below 3 V |
| Ignition switch off, MIL OFF | 11 to 14 V | |||
| J28-12 (CHG-) - Body ground | B - Body ground | CHARGE warning light | Ignition switch ON, CHARGE warning light ON | Below 1 V |
| Ignition switch ON, CHARGE warning light OFF | 11 to 14 V | |||
| J28-13 (TIRE) - Body ground | LG - Body ground | Tire pressure warning light input signal | Ignition switch ON, tire pressure warning light ON | Below 1.5 V |
| Ignition switch ON, tire pressure warning light OFF | 8 V or higher | |||
| J28-14 (SW) - Body ground | R - Body ground | Brake fluid level warning light signal | Ignition switch ON, Brake warning light ON | Below 1 V |
| Ignition switch ON, Brake warning light OFF | 11 to 14 V | |||
| J28-15 (WLVL) - Body ground | P - Body ground | Washer level warning | Ignition switch ON, Washer level warning ON | Below 1 V |
| Ignition switch ON, Washer level warning OFF | 11 to 14 V | |||
| J28-16 (B) - Body ground | B - Body ground | Turn signal L | Ignition switch ON, turn signal switch neutral position | Below 1 V |
| Ignition switch ON, turn signal switch turned to left | Alternating between below 1 V and 11 to 14 V | |||
| J28-17 (B) - Body ground | G - Body ground | Turn signal R | Ignition switch ON, turn signal switch neutral position | Below 1 V |
| Ignition switch ON, turn signal switch turned to right | Alternating between below 1 V and 11 to 14 V | |||
| J28-22 (ILL-) - Body ground | W - Body ground | Illumination signal | Headlight dimmer switch in neither tail nor head position | Below 1 V |
| Headlight dimmer switch in tail or head position | 11 to 14 V | |||
| J28-23 (EP) - Body ground | W-B - Body ground | Illumination ground | Always | Below 1 Ω |
| J28-24 (ES) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| J28-25 (E3) - Body ground | Y - Body ground | Fuel sender gauge ground | Always | Below 1 Ω |
| J28-26 (L) - J28-25 (E3) | V - Y | Fuel sender gauge | Ignition switch ON, fuel sender gauge ON | Below 1 V |
| Ignition switch ON, fuel sender gauge OFF | 11 to 14 V | |||
| J28-27 (S) - Body ground | L - Body ground | Oil pressure warning | Ignition switch ON, oil pressure warning ON | Below 1 V |
| Ignition switch ON, oil pressure warning OFF | 11 to 14 V | |||
| J28-29 (+S) - Body ground | V - Body ground | Speed signal (output) | Ignition switch ON, wheel turned slowly | Pulse generation |
| J28-30 (SI) - Body ground | LG - Body ground | Speed signal (input) | Ignition switch ON, wheel turned slowly | Pulse generation |
| J28-31 (P) - Body ground | GR - Body ground | A/T shift position signal P | Ignition switch ON, shift lever is except P position | Below 1 V |
| Ignition switch ON, shift lever is P position | 11 to 14 V | |||
| J28-32 (R) - Body ground | BR - Body ground | A/T shift position signal R | Ignition switch ON, shift lever is except R position | Below 1 V |
| Ignition switch ON, shift lever is R position | 11 to 14 V | |||
| J28-33 (N) - Body ground | L - Body ground | A/T shift position signal N | Ignition switch ON, shift lever is except N position | Below 1 V |
| Ignition switch ON, shift lever is N position | 11 to 14 V | |||
| J28-34 (D) - Body ground | G - Body ground | A/T shift position signal D | Ignition switch ON, shift lever is except D position | Below 1 V |
| Ignition switch ON, shift lever is D position | 11 to 14 V | |||
| J28-35 (4) - Body ground | P - Body ground | A/T shift position signal S | Ignition switch ON, shift lever is except S position | Below 1 V |
| Ignition switch ON, shift lever is S position | 11 to 14 V | |||
| J28-36 (MSSL) - Body ground | V - Body ground | DISP switch signal | Ignition switch ON, DISP switch OFF | 10 kΩ or higher |
| Ignition switch ON, DISP switch ON | Below 1 Ω | |||
| J28-37 (LP) - Body ground*2 | L - Body ground | Security indicator light signal | Immobiliser set status (SET) | Alternating between 11 to 14 V and below 1 V |
| Immobiliser set status (UNSET) | Below 1 V |
*1: w/ Intuitive Parking Assist System
*2: w/ Engine Immobiliser System
CHECK COMBINATION METER INNER CIRCUIT