DATA LIST
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream ON.
Enter the following menus: Body Electrical, Powertrain or Chassis / (desired system) / Data List.
According to the display on Techstream, read the "Data List".
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| ODO/TRIP Change SW | Trip switch (ODO/TRIP switch) condition/ON or OFF | ON: Trip switch (ODO/TRIP switch) pushed
OFF: Trip switch (ODO/TRIP switch) not pushed |
- |
| Vehicle Speed Meter | Vehicle speed/Min.: 0 (0), Max.: 255 (158) | Almost same as actual vehicle speed (when driving) | Unit: km/h (mph) |
| Engine Rpm | Engine speed/Min.: 0, Max.: 12750 | Idling: 700 to 800 | Unit: rpm |
| Coolant Temperature | Engine coolant temperature/Min.: -40 (-40), Max.: 140 (284) | After warming up: 80 to 105 (176 to 221) | ·
Unit: °C (°F) ·
If value -40 (-40): sensor circuit open ·
If value 140 (284): sensor circuit shorted |
| Washer Switch | Washer fluid level warning signal/ON or OFF | ON: Washer fluid level low
OFF: Washer fluid level not low |
- |
| Multi Display Select Switch | Steering pad switch (DISP)/ON or OFF | ON: Steering pad switch (DISP) pressed
OFF: Steering pad switch (DISP) not pressed |
- |
| +B Voltage Value | +B voltage/Min.: 0, Max.: 25.5 | Below 1 to 14 | Unit: V |
| Integrated value for Maintenance | Integrated value for oil maintenance warning/Min.: 0 (0), Max.: 25500 (41037) | 0 (0) to 25500 (41037) | Unit: mile (km) |
| Ambient Temperature | Outside temperature/Min.: -40°C (-40°F), Max.: 87.5°C (189.5°F) | Almost the same as actual outside temperature | - |
| Rheostat value | Light control rheostat switch input/Min.: 0, Max.: 100 | Light control rheostat switch is Dark (0) → Bright (100) | Unit: % |
| TPMS Operation State | The condition of the tire pressure/OFF, ON or Unknown | OFF: Tire pressure warning system not operated
ON: Tire pressure warning system operated Unknown: Wire harness between combination meter assembly and tire pressure warning ECU open |
- |
| Fuel Level | Fuel sender gauge input/Min.: 0, Max.: 127.5 | Fuel sender input value | Unit: L |
| Key Remind Sound | Key reminder sound/FAST, NORMAL or SLOW | Displays key reminder buzzer speed setting | - |
| Key Remind Volume | Key reminder volume/LARGE, MEDIUM or SMALL | Displays key reminder buzzer volume setting | - |
| Driver Side Seatbelt Warning Buzzer | Driver side seat belt warning buzzer setting/ON or OFF | ON: Driver side seat belt warning buzzer ON setting
OFF: Driver side seat belt warning buzzer OFF setting |
- |
| P-Seatbelt Warning Buzzer | Front passenger side seat belt warning buzzer setting/ON or OFF | ON: Front passenger side seat belt warning buzzer ON setting
OFF: Front passenger side seat belt warning buzzer OFF setting |
- |
| ODO Display Time After IG OFF Setting | Odometer display time setting/30 s, 60 s, 600 s or OFF | Displays odometer display time setting | - |
| Number of Trouble Code | Number of DTCs currently stored | 0 | - |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Engine Speed | Engine speed/Min.: 0, Max.: 16383.75 | Idling: 700 to 800 | Unit: rpm |
| Vehicle Speed | Vehicle speed/Min.: 0 (0), Max.: 255 (158) | Actual vehicle speed | ·
Unit: km/h (mph) ·
Speed indicated on speedometer |
| Coolant Temp | Engine coolant temperature/Min.: -40 (-40), Max.: 215 (419) | After warming up: 80 to 105 (176 to 221) | ·
Unit: °C (°F) ·
If value -40 (-40): sensor circuit open ·
If value 215 (419): sensor circuit shorted |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| (FL/FR/RL/RR) Wheel Speed | Wheel speed sensor (FL/FR/RL/RR) reading/Min.: 0 (0), Max.: 326 (202) | Actual wheel speed | Similar speed as indicated on speedometer |
ACTIVE TEST
Using the Techstream to perform the Active Tests allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream ON.
Enter the following menus: Body Electrical / (desired system) / Active Test.
According to the display on Techstream, perform the "Active Test".
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Speed Meter Operation*1 | Speedometer | 0, 40, 80, 120, 160 or 200 | Perform the test with the vehicle stopped and engine idling |
| Acceptable range (km/h or mph): [Control range → Speedometer display]
for mph ·
40 mph → 39 to 42.5 mph ·
80 mph → 79.5 to 84 mph ·
120 mph → 120 to 125.5 mph for km/h ·
40 km/h → 41.7 to 46.2 km/h ·
80 km/h → 83.4 to 88.4 km/h ·
120 km/h → 125.1 to 130.6 km/h ·
160 km/h → 166.2 to 173.2 km/h ·
200 km/h → 207.7 to 215.7 km/h |
|||
| Tacho Meter Operation | Tachometer | 0, 1000, 2000, 3000, 4000, 5000, 6000 or 7000 | Perform the test with the vehicle stopped and engine idling |
| Fuel Meter Operation | Fuel receiver gauge | OFF, Sender E, Empty, Warning, 1/4, 1/2, 3/4, Full or Sender F | Perform the test with the vehicle stopped and engine idling |
| Water Temperature Meter Operation | Engine coolant temperature receiver gauge | OFF, LOW, NORMAL or HIGH | Perform the test with the vehicle stopped and engine idling |
| Volt Meter Operation | Voltmeter | OFF, 0 V, 3 V, 6 V, 9 V, 12 V, 15 V or 18 V | Perform the test with the vehicle stopped and engine idling |
| Oil Pressure Meter Operation | Oil pressure receiver gauge | OFF, LOW, 1/4, 1/2, 3/4 or HIGH | Perform the test with the vehicle stopped and engine idling |
| A/T Indicator operation 1 | A/T indicator (normal mode) | OFF, L, 2, 3(M), 4(M), D, N, R or P | Perform the test with the vehicle stopped and engine idling |
| A/T Indicator operation 2 | A/T indicator (sequential mode) | OFF, 6 or Es | Perform the test with the vehicle stopped and engine idling |
| Meter Display 1 | Multi-information display | ALL or OFF | Perform the test with the vehicle stopped and engine idling |
| Indicat. Lamp Airbag | SRS warning light | ON or OFF | Perform the test with the vehicle stopped and engine idling |
| Indicat. Lamp Doors All Open | DOOR indicator light | ON or OFF | Perform the test with the vehicle stopped and engine idling |
| Driver Side Seat Belt | Front seat belt warning light | ON or OFF | Perform the test with the vehicle stopped and engine idling |
| Indicat. Lamp ABS | ABS warning light | ON or OFF | Perform the test with the vehicle stopped and engine idling |
| Indicat. Lamp Slip | SLIP indicator light | ON or OFF | Perform the test with the vehicle stopped and engine idling |
| Indicat. Lamp Beam | BEAM indicator light | ON or OFF | Perform the test with the vehicle stopped and engine idling |
| Indicat. Lamp Head*3 | HEAD indicator light | ON or OFF | Perform the test with the vehicle stopped and engine idling |
| Indicat. Lamp TAIL*4 | TAIL indicator light | ON or OFF | Perform the test with the vehicle stopped and engine idling |
| Indicat. Lamp Fuel | Low fuel warning light | ON or OFF | Perform the test with the vehicle stopped and engine idling |
| Indicat. Tire Pressure Warning System | Tire pressure warning light | ON or OFF | Perform the test with the vehicle stopped and engine idling |
| Indicat. 4WD*5 | 4HI indicator light | ON or OFF | Perform the test with the vehicle stopped and engine idling |
| Indicat. 4LO*5 | 4LO indicator light | ON or OFF | Perform the test with the vehicle stopped and engine idling |
| Indicat. Lamp Cruise*2 | Cruise control indicator light | ON or OFF | Perform the test with the vehicle stopped and engine idling |
| Indicat. SET*2 | SET indicator light | ON or OFF | Perform the test with the vehicle stopped and engine idling |
| Indicat. Lamp Brake | Brake warning light | ON or OFF | Perform the test with the vehicle stopped and engine idling |
| Master Warning | Master warning light | ON or OFF | Perform the test with the vehicle stopped and engine idling |
| Indicat. Auto LSD | AUTO LSD indicator light | ON or OFF | Perform the test with the vehicle stopped and engine idling |
| TOW HAUL Indicator | TOW HAUL indicator light | ON or OFF | Perform the test with the vehicle stopped and engine idling |
| Indicat. VSC OFF | VSC OFF indicator light | ON or OFF | Perform the test with the vehicle stopped and engine idling |
*1:
It is normal that door will be locked automatically when performing the speedometer Active Test.
The displayed value has the same units (km/h, mph) as the main scale of the vehicle's speedometer.
The needle position should be within the acceptable tolerance.
*2: w/ Cruise Control System
*3: for U.S.A.
*4: except U.S.A.
*5: for 4WD