The combination meter communicates with the ECM via the CAN line.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0100 | When either of following conditions is detected:
·
Vehicle speed 5 km/h (3 mph) or more and IG voltage 10.5 V or more ·
No communication with ECM continues for 3 seconds or more (No communication to ECM or skid control ECU continues for 60 seconds or more) |
CAN communication system |
Check for DTCs and note any codes that are output (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR).
Clear the DTC (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR).
Recheck for DTC (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC U0100 is not output | A |
| DTC U0100 is output | B |
If the CAN communication system DTC U0100 and another DTC are output at the same time, perform troubleshooting for the CAN communication system DTC U0100 first.
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B