Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM
RM27M0U _56 Audio / Visual / Telematics _049158 NAVIGATION / MULTI INFO DISPLAY _0234440 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Display does not Dim when Light Control Switch is Turned ON  


PROCEDURE

1.CHECK IMAGE QUALITY SETTING
a.

Display the "Display" screen.


b.

Turn the light control switch to the tail or head position.


c.

Check if "Day Mode" on the display adjustment screen is on.

OK:

"Day Mode" setting is off




OK

2.CHECK VEHICLE SIGNAL (OPERATION CHECK)

NG

TURN "Day Mode" SETTING OFF

2.CHECK VEHICLE SIGNAL (OPERATION CHECK)
a.

Enter the "Vehicle Signal Check Mode" screen. [Refer to Check Vehicle Signal in Operation Check (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>OPERATION CHECK)]


E278187

b.

Check that the display for "TAIL" changes between ON and OFF according to the light control switch operation.

OK:
Light Control Switch Display
Tail or head ON
Off OFF


HINT:

This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.



c.

Check that the display for "ADIM/TCAN" changes between DIM and BRIGHT according to the light control switch operation.

OK:
Light Control Switch Display
Tail or head DIM
Off BRIGHT


Result
Result Proceed to
OK (for Column Shift Type) A
OK (for Floor Shift Type) B
NG C



A

B

C

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE