This circuit is used when the voice guidance in the navigation system is on or an incoming cellular phone voice in the "Bluetooth" hands-free system is heard.
Using this circuit, the navigation receiver assembly sends the signals to the stereo component amplifier assembly.
Disconnect the J134 navigation receiver assembly connector.
Disconnect the J141 stereo component amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J141-23 (II1+) - J134-2 (RL+) | Always | Below 1 Ω |
| J141-22 (II1-) - J134-6 (RL-) | Always | Below 1 Ω |
| J141-23 (II1+) - Body ground | Always | 10 kΩ or higher |
| J141-22 (II1-) - Body ground | Always | 10 kΩ or higher |
| J141-6 (SLD) - Body ground | Always | 10 kΩ or higher |
OK
(See pageAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE)
NG