Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM
RM27M0U _56 Audio / Visual / Telematics _049158 NAVIGATION / MULTI INFO DISPLAY _0234440 NAVIGATION SYSTEM C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  B1579  Voice Recognition Microphone Disconnected  


DESCRIPTION

The navigation receiver assembly and roof console box assembly (telephone microphone assembly) are connected to each other using the microphone connection detection signal lines.

This DTC is stored when a microphone connection detection signal line is disconnected.

DTC Code DTC Detection Condition Trouble Area
B1579 Telephone microphone signal is lost.
·

Navigation receiver assembly

·

Roof console box assembly

·

Telephone microphone assembly

·

Harness or connector



WIRING DIAGRAM

E280091E17
0.854,0.844 1.583,1.365 0.729,0.521 10 false Telephone Microphone Assembly 1.813,0.438 2.354,0.646 0.542,0.208 10 false ACC 1.833,2.031 2.344,2.25 0.51,0.219 10 false SNS2 1.833,0.865 2.365,1.073 0.531,0.208 10 false MI1+ 1.844,1.25 2.76,1.458 0.917,0.208 10 false MIC- 2.313,0.417 2.823,0.635 0.51,0.219 10 false 10 2.302,0.865 2.813,1.083 0.51,0.219 10 false 9 2.313,1.25 2.823,1.469 0.51,0.219 10 false 8 2.302,2.052 2.813,2.271 0.51,0.219 10 false 14 0.51,2.552 1.021,2.771 0.51,0.219 10 false W7 0.531,2.75 2.573,3.01 2.042,0.26 10 false Roof Console Box Assembly 5.469,0.469 5.719,0.635 0.25,0.167 10 false 4 5.479,0.844 5.729,1.01 0.25,0.167 10 false 5 5.417,1.25 5.667,1.417 0.25,0.167 10 false 19 5.417,1.635 5.667,1.802 0.25,0.167 10 false 18 5.438,2.042 5.688,2.208 0.25,0.167 10 false 6 5.646,0.552 6.26,0.729 0.615,0.177 10 false MACC 5.677,0.969 6.292,1.146 0.615,0.177 10 false MIN+ 5.667,1.344 6.281,1.521 0.615,0.177 10 false MIN- 5.667,1.729 6.281,1.906 0.615,0.177 10 false SGND 5.688,2.177 6.302,2.354 0.615,0.177 10 false SNS2 5.542,2.5 6.156,2.677 0.615,0.177 10 false J135 5.552,2.688 6.813,3.01 1.26,0.323 10 false Navigation Receiver Assembly 3.156,1.885 3.771,2.063 0.615,0.177 10 false Shielded 4.375,1.896 4.99,2.073 0.615,0.177 10 false Shielded

PROCEDURE

1.CHECK NAVIGATION RECEIVER ASSEMBLY
a.
U152833E02
2.052,1.302 2.167,1.896 2.167,1.896 2.396,1.896 true 2.177,1.302 2.406,1.667 2.406,1.667 2.635,1.667 true 2.177,1.104 2.427,0.417 2.427,0.417 2.698,0.417 true 2.417,1.802 2.781,1.979 0.365,0.177 10 false MIN- 2.656,1.573 3.104,1.75 0.448,0.177 10 false SGND 2.74,0.333 3.188,0.51 0.448,0.177 10 false MACC 0.063,0.042 0.302,0.219 0.24,0.177 10 false *a 0.229,1.042 0.719,1.219 0.49,0.177 10 false J135

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
J135-18 (SGND) - Body ground Always Below 1 Ω
J135-19 (MIN-) - Body ground Always Below 1 Ω



b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
J135-4 (MACC) - Body ground Ignition switch ACC 4 to 6 V


Text in Illustration
*a Component with harness connected
(Navigation Receiver Assembly)


Result
Result Proceed to
OK A
NG (for Column Shift Type) B
NG (for Floor Shift Type) C


A

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - ROOF CONSOLE BOX ASSEMBLY)

B

C

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - ROOF CONSOLE BOX ASSEMBLY)
a.

Disconnect the J135 navigation receiver assembly connector.


b.

Disconnect the W7 roof console box assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
J135-4 (MACC) - W7-10 (ACC) Always Below 1 Ω
J135-5 (MIN+) - W7-9 (MI1+) Always Below 1 Ω
J135-19 (MIN-) - W7-8 (MIC-) Always Below 1 Ω
J135-6 (SNS2) - W7-14 (SNS2) Always Below 1 Ω
J135-4 (MACC) - Body ground Always 10 kΩ or higher
J135-5 (MIN+) - Body ground Always 10 kΩ or higher
J135-19 (MIN-) - Body ground Always 10 kΩ or higher
J135-18 (SGND) - Body ground Always 10 kΩ or higher
J135-6 (SNS2) - Body ground Always 10 kΩ or higher




OK

3.CHECK TELEPHONE MICROPHONE ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK TELEPHONE MICROPHONE ASSEMBLY
a.

Replace the telephone microphone assembly with a known good one (See page Audio / Visual / Telematics>AUDIO / VIDEO>MICROPHONE AMPLIFIER>REMOVAL).


b.


OK

END (TELEPHONE MICROPHONE ASSEMBLY IS DEFECTIVE)

NG

REPLACE ROOF CONSOLE BOX ASSEMBLY