Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM
RM27M0U _56 Audio / Visual / Telematics _049158 NAVIGATION / MULTI INFO DISPLAY _0234440 NAVIGATION SYSTEM C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  B158F  AV Signal Stoppage (Low Battery Voltage)  


DESCRIPTION

This DTC is stored when a video or audio signal is interrupted due to battery voltage input to the navigation receiver assembly dropping temporarily.

DTC Code DTC Detection Condition Trouble Area
B158F A video or audio signal is interrupted when the battery voltage drops.
·

Navigation receiver assembly

·

Harness or connector



WIRING DIAGRAM

E280930E02
0.838,0.976 1.684,1.183 0.846,0.207 10 from Battery 3.155,1.163 4.715,1.347 1.560,0.184 10 RAD NO. 1 5.074,0.892 5.198,1.076 0.123,0.184 10 4 5.252,0.99 5.782,1.169 0.531,0.179 10 +B1 5.01,1.901 5.425,2.061 0.415,0.161 10 J133 5.01,2.05 6.300,2.387 1.290,0.336 10 Navigation Receiver Assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK VEHICLE SIGNAL (OPERATION CHECK)
a.
E268487

Enter the "Vehicle Signal Check Mode" screen. [Refer to Check Vehicle Signal in Operation Check (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>OPERATION CHECK)]


b.

Check that the battery voltage.

Standard voltage:

11 to 14 V


HINT:

This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.




OK

2.CHECK FOR DTC

NG

3.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY POWER SOURCE)
2.CHECK FOR DTC

b.

Check for DTCs (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).

OK:

No DTCs are output.


Result
Result Proceed to
OK A
NG (for Column Shift Type) B
NG (for Floor Shift Type) C



A

B

C

3.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY POWER SOURCE)
a.
U152825E01
1.504,0.333 1.885,0.517 0.381,0.184 10 J133 2.825,0.475 3.138,0.659 0.312,0.184 10 +B1 0.083,0.045 0.396,0.229 0.312,0.184 10 *a 2.304,0.949 2.55,0.563 2.55,0.563 2.816,0.563 false

Disconnect the navigation receiver assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
J133-4 (+B1) - Body ground Always 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Navigation Receiver Assembly)

Result
Result Proceed to
OK (for Column Shift Type) A
OK (for Floor Shift Type) B
NG C



A

B

C

REPAIR OR REPLACE HARNESS OR CONNECTOR