Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
87906B
1.REMOVE OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH
Push the upper part of the mirror surface and tilt it.
Using moulding remover D, push the bottom of the outer rear view mirror sub-assembly LH upwards as shown in the illustration. Slide the outer rear view mirror sub-assembly LH upwards to detach the 4 claws, and then remove the outer rear view mirror sub-assembly LH.
| *1 | Moulding Remover D |
| *2 | Protective Tape |
Apply protective tape to the outer rear view mirror assembly LH to prevent it from being damaged.
w/ Mirror Heater:
Disconnect the 2 connectors and remove the outer rear view mirror sub-assembly LH.
w/ Retract Mirror:
Disconnect the 3 connectors and remove the outer rear view mirror sub-assembly LH.
w/ Blind Spot Monitor:
Using a screwdriver, disconnect the 3 connectors and remove the outer rear view mirror sub-assembly LH.
| *1 | Protective Tape |