Home › Vehicle Interior › MIRROR › POWER MIRROR CONTROL SYSTEM(w/ Memory)
RM27M0U _58 Vehicle Interior _049162 MIRROR _0234477 POWER MIRROR CONTROL SYSTEM(w/ Memory) U

MIRROR  POWER MIRROR CONTROL SYSTEM(w/ Memory)  DATA LIST / ACTIVE TEST  


READ DATA LIST


HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch ON.


c.

Turn the tester on.


d.

Enter the following menus:

i.

Techstream - Select: Body / (desired system) / Data List.



e.

According to the display on, read the "DATA LIST".

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Mirror Selection SW (R) Mirror master switch signal for RH mirror / ON or OFF ON: Switch is in R position
OFF: Switch is OFF or in L position
-
Mirror Selection SW (L) Mirror master switch signal for LH mirror / ON or OFF ON: Switch is in L position
OFF: Switch is OFF or in R position
-
Mirror Position SW (R) Mirror control switch signal (RIGHT) / ON or OFF ON: RIGHT switch is ON
OFF: Any switch except RIGHT is ON or all switches are OFF
-
Mirror Position SW (L) Mirror control switch signal (LEFT) / ON or OFF ON: LEFT switch is ON
OFF: Any switch except LEFT is ON or all switches are OFF
-
Mirror Position SW (UP) Mirror control switch signal (UP) / ON or OFF ON: UP switch is ON
OFF: Any switch except UP is ON or all switches are OFF
-
Mirror Position SW (Dwn) Mirror control switch signal (DOWN) / ON or OFF ON: DOWN switch is ON
OFF: Any switch except DOWN is ON or all switches are OFF
-
Outer Mirror Fold SW Mirror retract switch signal / ON or OFF ON: Switch is ON (retracting)
OFF: Switch is OFF
-

Mirror
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Mirror Memory No.1 Driver side mirror position memorized in seat memory switch M1 / ON or OFF ON: Memorized
OFF: Not memorized
-
Mirror Memory No.2 Driver side mirror position memorized in seat memory switch M2 / ON or OFF ON: Memorized
OFF: Not memorized
-
RH Mir Position Sensor V Passenger side mirror vertical sensor voltage / MIN: 0, MAX: 255 Within range from 0 to 255 -
RH Mir Position Sensor H Passenger side mirror vertical sensor voltage / MIN: 0, MAX: 255 Within range from 0 to 255 -
LH Mir Position Sensor V Driver side mirror vertical sensor voltage / MIN: 0, MAX: 255 Within range from 0 to 255 -
LH Mir Position Sensor H Driver side mirror vertical sensor voltage / MIN: 0, MAX: 255 Within range from 0 to 255 -



PERFORM ACTIVE TEST


HINT:

Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Warm up the engine.


b.

Turn the ignition switch OFF.


c.

Connect the the Techstream to the DLC3.


d.

Turn the ignition switch ON (IG).


e.

Turn the on.


f.

Enter the following menus:

i.

Techstream - Select: Body Electrical / MIRROR / Active Test.



g.

According to the display on tester, perform the "ACTIVE TEST".


h.

Techstream

Mirror
Tester Display Test Part Control Range Diagnostic Note
RH Mirror Up/Down Mirror vertical operation UP / OFF / DOWN -
RH Mirror Right/Left Mirror horizontal operation RIGHT / OFF / LEFT -
LH Mirror Up/Down Mirror vertical operation UP / OFF / DOWN -
LH Mirror Right/Left Mirror horizontal operation RIGHT / OFF / LEFT -
Mirror Fold Mirror retract operation FOLD / OFF -
Mirror Return Mirror retract operation RETURN / OFF -