Home › Vehicle Interior › EXTERIOR › REAR BUMPER(for Steel Type Bumper)
RM27M0U _58 Vehicle Interior _049164 EXTERIOR _0234482 REAR BUMPER(for Steel Type Bumper) A

EXTERIOR  REAR BUMPER(for Steel Type Bumper)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

As the rear bumper cover is extremely heavy, the engine lifter may suddenly drop if the instructions listed in the repair manual are not followed. Therefore, always follow the instructions listed in the repair manual when performing this procedure.


PROCEDURE

Hide 1.INSTALL REAR BUMPER COVER

a.

w/ Towing Package:

i.

Using an engine lifter or equivalent, install the rear bumper cover with the 12 bolts.

Torque:
153 N*m (1560 kgf*cm, 113 ft.*lbf)

NOTICE:
·

Using plate lift attachments or equivalent, set the rear bumper cover on a flat surface.

·

Be sure to perform the operation with 2 persons or more.

·

Be careful not to damage the rear bumper cover.





b.

w/o Towing Package:

i.

Using an engine lifter or equivalent, install the rear bumper cover with the 8 bolts.

Torque:
153 N*m (1560 kgf*cm, 113 ft.*lbf)

NOTICE:
·

Using plate lift attachments or equivalent, set the rear bumper cover on a flat surface.

·

Be sure to perform the operation with 2 persons or more.

·

Be careful not to damage the rear bumper cover.





Hide 82824X 2.INSTALL WIRING HARNESS CONNECTOR (w/ Towing Package)

a.

Attach the 2 claws to install the wiring harness connector.


b.

Connect the connector.


Hide 82821A 3.INSTALL CONNECTOR COVER (w/o Towing Package)

HINT:

Use the same procedure described for the wiring harness connector.